This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hello!
I set up a project using NRF24L01 and a patch antenna ceramic, the type used in GPS.
In fact, I tested several types of antennas, F, F inverted, GPS, Loop. But...
Hello fellow devlopers.
I am experienceing very odd behaviour from the UART peripheral.
I am trying to ouput a uint8_t[48] array from the UART termainl. I am using this...
Two questions about the smart beacon PCB that is not in the design file.
1.) What PCB material did you use exactly?
2.) What type of solder mask did you use
Thank...
I compile the coap client example and drag-n-drop the hex file to a RBL BLE Nano. However, no advertising packets picked up by sniffer. Is it possible to port IoT SDK to a...
I followed the instructions in developer.nordicsemi.com/.../a00058.html and reached Obtaining the kernel: Option 2: Native build. I failed at step 3 and the error message...
Hi,
after getting the way to write to peripheral on this link I have successfully
written 20 bytes packet.
but I'm facing a latency while writing back to back data packets...
Hi all,
I'm really new to the BLE scene so I'm having some trouble wrapping my head around how to send/receive data over BLE between a central/peripheral device. In my...
We have a working application on SDK 6.X.X and I just saw that there is a new update with SDK 7.1.0
Few questions:
In the release notes for SDK 7.0.0 it states that...
Hi,
I'm using Central multilink peripheral example to get connected with Our Custom Peripheral App (iOS). I'm able to receive the data from Peripheral device, Now i need...
SDK_9.0.0
I was trying to implement 2 different UART connection parameters so I decide to use re-initialization.
My initial parameters included APP_UART_FLOW_CONTROL_LOW_POWER...
Hi, I want to get the RSSI values as much quick as possible. I have written a code which is transmitting at 10Hz for instance(that is sufficient). But The problem is that...
Dear Nordic Developers,
I'm trying to write some data to a slave and when the slave gets the write command sends back a notification. My problem is that I send the write...
I would like to use nRF51422 in commercial product and I use your SDK. There are 2 files: app_uart.h and app_uart_fifo.c that I would like to modify a bit. I would like to...
Hi,
I have PCA10028 dev board and Fujitsu MBH7BLZ02 BT module.
I have successfully modified some sample code and when I flash it to nRF module on the PCA board, the...
