i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
When using the BLE device, BLE_GAP_EVT_DISCONNECTED event informs us that connection between dongle and BLE device was closed/lost.
Is there a way to know when dongle connection...
When using nrf51-ble-driver_win_0.3.0 with Visual Studio 2010, after I put a breakpoint in my code, when I try to have the process "continue", I always get unandles exception...
Hi,
I am using nRF52840-DK evaluation for testing a Mesh configuration. I was able to successfully establish a mesh connection with a onoff-sample from zephyr and was able...
I am working on the project with radio transmitter(NRF24L01+) and receiver(NRF52840). I need to receive data at the rate of 250kbs. I tried to receive but it fails always...
Hello,
I want to interface a microcontroller with the nRF52832 chip in one of our designs. The microcontroller will be running on FreeRTOS.
I would like to know a few...
Hi,
We are currently in a testing phase of our software where we use an nRF52832 for extended advertising and an nRF52840 for scanning that has a scan interval and scan...
Hello, i´m trying make DFU with the Light switch server with the GATT and Proxy Enable, however in the process of update, i got this error in the device what receive the update...
Trying to lower uC current consumption to minimum
Im trying to remove features from my program
I've notice that removing the adc initialization actually get the current...
Hi All
I mount a minimum system for test BLE. I download a blinky program to the NRF52810. If I download a blinky without BLE version , it works well . But if I download...
Hi dear Nordic engineers and enthusiasts,
I am currently testing and researching on the functionalities of Nordic Thingy 52 in Bluetooth Mesh . I have tested with the provided...
Hi
I am trying to use the TWI on nrf52840 but i am unable to get it to work. its getting stuck somewhere. I dont have a logic analyzer so i am unable to check if the signal...
Hi,
I'm doing some experimental evaluation of BLE Long Range. I use the ble_app_att_mtu_throughput example with parameters:
ATT MTU: 247 bytes
Data length extension...
I am trying to test out the whitelist that I have created for the nrf52832 client. I have edited the whitelist so it will only allow one device to be bonded and added to the...
Hello, We have choose NRF52840-QIAA-R for our design, can you give me more infrmation on microvia use between layer 1 and layer 2 please?
What is drilling and pad dimension...
hello,
When looking at the 3 different migrations scenarios at
https://www.nordicsemi.com/DocLib/Content/SDK_Doc/nRF5_SDK/v15-2-0/nrfx_migration_user_guide#getting_started_replace_nrf_drv_options_migrate...
