But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi, we are trying to work with nRF52840. We have a problem that our hardware goes into continuous reboot mode when we disconnect the JLINK debugger. The disconnect can be...
Hi，
I'm doing a rssi detect test based on nordic mesh sdk 2.2, it runs well when connect to a computer running SES by j-link, but almost don't work when running on board...
Greetings
Newbie question:
Im new to this BLE and RF world, and i'm trying to read all the info i can before buy the nRF52 DK when it got the IC without all the "erratas...
Hallo
Im using the example of nRF5_SDK_12.3.0_02\nRF5_SDK_12.3.0_d7731ad\examples\peripheral\uart
to setup a uart that includes rx as well as tx,
I am running the...
Hello everyone, I'm new with Nordic devices.
Actually wanted to get services correspondant to I2C slave addresses and registers.
I was thinking about using the SDK template...
i am using nrf52832 in sdk11. I am interfacing motion sensor and spi flash memory. Both motion sensor and spi flash shares spi lines and having different chip select pin....
Hello
I'm implementing light switch demo code, but while build client and server code getting error
Building ‘light_switch_client_nrf52840_xxAA_s140_6.1.0’ from solution...
Dear Nordic Team,
Thanks for supporting.
Now start to work with nRF52810 chip. Already i am worked on nRF52832 based projects. Now i want to know the s112 soft device...
The GTT was great!
And the Solar panel demo was impressive.
We are very interested in integrating solar panel with nRF52 on our upcoming BLE products.
It would be great...
hi...
i want to check how the sleep mode is working so i am testing with the simple uart program
here you can see the code .. ble_nus is not sending the data in ble_uart...
Hello, I am using SDK15.2 on nrf52 DK with SD 6.1.0 and having an issue in long button press action. The single press and long press button action work ok before BLE connection...
Hi,Sir
We are keyboard developers and manufacturers,and we are using nrf51802 based on nrfready_desktop_2_v3.1.0,Our keyboards products works well,but recently we noticed...
