Hi, could you please tell me if my assumptions below correct?
Measuring a (ratiometric to VCC) analog signal and selecting VDD_1_2_PS as the reference selecting AIN_NO_PS...
When I initialize the SoftDevice with SOFTDEVICE_HANDLER_INIT(NRF_CLOCK_LFCLKSRC_XTAL_20_PPM, false); // Sets up Crystal Source to 20ppm 32.7628kHz
The project I based...
I am trying to make a product with NRF8002B. I finally have the product prototyped. The user will connect to the device, beep, light up, and track. It will always stay on...
Please,
It seems that "Flow Control" signal is not available on nRF24AP2-USB.
EVENT_TRANSFER_TX_START event message appears only one time after the first data packets...
I am looking for cheapest (up to few hundred USD) and simplest Arduino basic solution to track real-time RFID tags distance (also direction if possible) without additional...
Hi all,
I am new to Nordic semiconductor but I could be interessed by nRF9E5. To check if it could fit my requierement, I would like to know if it possible to configure...
Hello Nordic team
I am working on nRF52832 Dk, SDK v15.2, example "ble_app_buttonless_dfu".
Following code snippets is the GPIO configuration for pin interrupt:
ret_code_t...
Where can I find the hardware files (PCB, board layout, schematics, etc.) for the Thingy?
There seems to be a vague reference to zip file but no link.
There seems to no...
Hi All.
We are trying to do DFU on a device using s132_nrf52_5.0.0_softdevice.hex.
The DFU interrupts first time when it is around 15-20% complete.
When the DFU is attempted...
Hi!
I am using nrf52840,sdk 14.2,Keil IDE
I am using bmp180 and mpu6050 sensors.
In proximity code,I have integrated both sensors separately,It works fine.
But while...
Hi all
i'm new in both this site and nrf52
i have a question
Is there ADC CONFIG register in nrf52? i can't find ADC_CONFIG in nrf52
NRF_ADC->CONFIG = (ADC_CONFIG_EXTREFSEL_None...
I have an application where I am sending a fixed packet length of 32 bytes to data pipe 1.
I have set the data width to 32,
I have auto acknowledge enabled on P1.
I...
Hi,
I designed a nRF52832_xxAA board, I can't find the bluetooth name in iphone - settings - Bluetooth - Devices, but I can read/write and notify in myself mobile app and...
Hello,
I am using sdk version 15.2.0 and nrf52840. In the application NAND flash TC58CYG2S0HRAIG is used. We are using flash to store values which we receive from the USB...
1.I want to know whether there is any existing network in the same channel .And get the existing network's information like PAN ID.
Any APIs to do this?
2.How to set...
Hi,
I'm trying to run a display using SPI, and I've run into some troubles. I've attached my code below:
My issue is that the program never gets past the while loop...
Hi,
I am getting the GATT ERROR during init packet stage during firmware upgrade. I am using SDK 14.2 and nRFConnect application on Samsusng Galaxt S8. It looks like I am...
Dear Team
We have selected nRF52840 in our design.
I am layout designeer.
Please send refenrence layout section for nRF52840 to me.
I want study rhe layout design...
Hi,
I am currently developing Bluetooth Mesh for our battery powered products which needs to be updated on demand.
I am running the Mesh light switch examples on the...
