Hi all,
I am new to Nordic semiconductor but I could be interessed by nRF9E5. To check if it could fit my requierement, I would like to know if it possible to configure...
Hi,
I am using ADC without external reference and no analog input in order to measure the battery level with a timer (code at the end).
I am also reading several ports...
Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
I use nrf52832 sdk 14.0
SD+ boot(for ota）+app
In the applicaiton there are some user data to save. I used two pages ( one pages start from 0x6E000 and the other start...
Hello!
A few questions about the flashlog:
1. What's the difference between the flashlog and the crashlog?
2. What is the recommended way to obtain flashlog/crashlog...
Hello Team, I am a student majorly interested in wearable designing and manufacturing field. Recently I have designed a small wearable PCB which barely contains components...
Hi all!
It`s possible to know in event BLE_EVT_TX_COMPLETE which characteristic sent a notifiation?
I have 2 characteristic and depending on which one of them sent notification...
Hi,
The product description of pickit4 on microchip website( https://www.microchip.com/developmenttools/ProductDetails/PG164140 ) says that it support swd. So I'm wondering...
Hi,
nRF51822. I'd like to detect single-click, double-click, triple-click, etc. button press sequences. Multiple clicks are when the next button press is within 1/2second...
we are using latest repository, did " west update" to pull the source code. Followed nrf connect application "getting started assistant" to setup the environment.
All the...
In 15.3, there is a new application type valid for DFU, external app. When loaded through DFU, the program just sits there in bank1, and doesn't get sent anywhere. I'd like...
Hi, I'm trying to use the iOS nRF Mesh Library on GitHub: https://github.com/NordicSemiconductor/IOS-nRF-Mesh-Library
I've managed to install the iOS app, but I am unsure...
Hello,
I'm attempting to connect the nRF9160 DK to our AWS IoT account. I've been following the information in this question: https://devzone.nordicsemi.com/f/nordic-q-a...
Hi, looking for some advice regarding hardfault analysis. Using NRF52840 with SDK 15.3 and SD 6.1.0, i am seeing occasional hard fault (after ~30 min to 2 hours), during relatively...
Hi,
I know it is a silly question but I would like to ask does nRF52810 support SPI, TWI, UARTE etc.
Below is block diagram from datasheet of nRF52810 which shows it has...
