I'm trying to perform communication between my device and iOS and I ran into some problems. For tests I'm using iPod touch 5 with nRF Toolbox and LightBlue apps and nRF51822...
I've been using Master Emulator API 2.1.3 in Visual Studio 2010 Express, and have spotted a fix I may need in 2.1.5 so I've switched to using the 2.1.7 API. However, I've...
Hello,In normal condition, I use UART,pwm,spi an so on.Now I want to clear the configuration, and enter System ON mode.But I don't want to system reset.
How should I do...
Hi, everyone~
My goal is to collect data from 4 sensors simultaneously using iPhone.
Now, my testing code for sensor nodes is working fine. It was built based on the...
I am an android developer and I am using your nRF Master Control Panel (BLE) product as published on Google play. Below is the link to the app:
play.google.com/.../details...
I want to build a USB dongle, so I purchased the nrf24lu1+ development kit. However, in order to program the target board, it would seem that I need the nrfgo. Is this correct...
Hi,
I am using nCS on nrf52833 based BL653dvk, I am based on default 32kHz CPU frequency. I need to go higher up to 40MHz, kindly suggest what configuration options I...
Hi,
I'm a newbie here.
I have a device using NRF52840 running SDK17 with SD v7 configured as a Central/Observer device doing Active Scan.
I have a few questions:
...
Hello
I am developing a board using nRF52840. I have one doubt i can used internal regulator when i power on vddh and how to select voltage level My requirement is 3.3V...
I want to use UART in the ble_app_multilink_central example. I got the Serial example project working but at the moment of moving all the sdk_config.h flags I just receive...
Hi, I want to my central device to search for peripherals by specific, hardcoced IRKs. I have setup whitelist that cooperates with bonding and peer manager. The thing is that...
I have gone through one example "servo_motor" using PWM method to control motor direction, but that seems little different from what I want to develop.
I am having nRF5340...
Hi,
I´m trying to read my ADC values. I powered de DK with USB and trying to read sensormeasurements, but I can´t see the right values.
I´m trying to read with the 12...
Hello Nordic support:
Our product used nRF52840, nRF5_SDK_17.1.0 s140_nrf52_7.2.0_softdevice.hex. Could you help us to fill the form of bluetooth BQB certification test...
I am the user who is using nrf52832. A 1:Nble connection was successful using the multi-central example. I set the tx power of the device using sd_ble_gap_tx_power_set()....
Hi,
I have successfully built my application using the VS Code nRF build function. I am now trying to build an application using the West command in the terminal by following...
nRF Connect for VS Code v2022.9.179 on MacBook Pro M1. The new nRF Debug in VSCode hangs before main starts. If I switch back to Cortex-Debug then I can debug.
Hi,
In one of my application based on SDK 15.2, I am using nRF52832 as a central scanning device for 128 BLE beacons
My question is how often is the ble_gap_evt_adv_report_t...
