I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
Hi,
I tested the nrf beacon application, it allows only the beacons with company identifier 0x0059 (nordic's id). But i need to modify it to support all the device, how...
I use a app_timer_create() function to create a task(200ms once)
when in the task_timeout_handle() ,
I do something more than 200ms,
what will this timer going ?
Hi!
I use nrf51-pwm-library ( github.com/.../) to control brightness of LED RGB light source and it works ok till I don't want to adjust brightness slowly (dimming function...
hello,
are there any completed sample code of using pwm0, 1?
just 2 or 3 word can working like following? or need other config?
pwmcon=xx;
pwmdc0=xx;
pwmdc1=xx;
also...
Hi
I have a nrf52840 dongle with which already been flashed with ot-NCP binary and I want to over write this binary with new binary image[ot-rcp] in nrf connect for desktop...
hello,
I'm working with nRF52840 dongle, i installed nRF Connect for desktop v3.6.1 on ubunto 18.4 and i am using python3. After programming connectivity_4.1.4_usb_with_s132_5...
Hello I'm using Zephyr and trying to update the characteristic value with interval of 50ms. The problem is that the android app nrf connect freezes after I start reading the...
Hi,
I'm trying to run the light_switch sample app from nRF SDK for Mesh.
I have both PCA10056 and PCA10059, and I used both to run some other applications before testing...
Hi. I'm evaluating the nRF52810 chip by developing on the nRF52-DK (based in nRF52832 chip). As noted in this chapter https://infocenter.nordicsemi.com/topic/sdk_nrf5_v17...
We need to work with the PWM, the idea is to set one frequency, duty 50%, and put out these pulses to one pin, we understand how to do that but we need to stop these pulses...
Hi,
I once got the following message while trying to attach a debugger to my network core.
After this event, I haven't been able to program my network core.
I have...
I am looking at the hardware design of Thingy91, where the antenna is shared by LTE and GPS/GNSS. My system will be connected to a cloud (probably most of the time) and track...
Hi,
Our NRF52840 (running 14.2) often takes a very long time to disconnect, from when a disconnection is initiated by the phone. It can take 30s, sometimes even more, for...
Hi,
I'm using 5 nordic thingy 52 (nRF6936).
I connect all of them with my android smartphone using your thingylib library ( github ) and read only `rawDataNotification...
I have a nrf52832 based device with several GATT services which are used by custom IOS/Android applications via a paired phone. All of this is working correctly.
I would...
Bug in the SDK function below. channel_free is called whether or not pin_in_use_by_te() is true or not. For us this resulted in channel_free() getting called with an invalid...
