Hello,In normal condition, I use UART,pwm,spi an so on.Now I want to clear the configuration, and enter System ON mode.But I don't want to system reset.
How should I do...
Hi, everyone~
My goal is to collect data from 4 sensors simultaneously using iPhone.
Now, my testing code for sensor nodes is working fine. It was built based on the...
I am an android developer and I am using your nRF Master Control Panel (BLE) product as published on Google play. Below is the link to the app:
play.google.com/.../details...
I want to build a USB dongle, so I purchased the nrf24lu1+ development kit. However, in order to program the target board, it would seem that I need the nrfgo. Is this correct...
Hi Nordic,
I would like to re/program my device using a OTA BLE Bootloader but i don't want others to copy my firmware or at least make it very hard. As far as i know there...
After modifying the ancs example to remove the data and control points, the event_connect() subfunction in ble_ancs_c.c gets called immediatly upon a connection to a master...
Hi there,
Can we please get an updated example for Appendix 5 in this blog ?
Specifically the DFUMaster_SPI and the bootloader_secure_SPIS. Ideally it would be compatible...
Hi!
I was trying the throughput example using two nRF5340PDK boards and I observed the throughput is very low, i.e. 1kpbs. I tried programming the cpuappns, but it didn...
Hello! Reading the following segment regarding Buttonless DFU with bonds from the documentation, I'm not clear as to the meaning of these paragraphs. It looks like two contradicting...
Hi
i am able to work with adc 0 for nrf9160 custom borad now i want to use adc 5 to adc 7 simultanuously can you please guide me to settings which i need to modify or a...
Hii guys ,
I am trying to pair two nrf52 bluetooth devices. How can we pair two stand alone nrf52 devices to send and receive data? Is there any example code to show such...
Hello community!
I have curious problems with the bootloading process in SDK 17.0.2 . What I am trying to do is the following:
1. Create a bootloader settings page with...
Hi there!
We are using nRF52840DK development kit with nRF-Connect SDK to build a pre-production version of our product.
We need more GPIO configurations for our project...
Hello Nordic, I am currently trying to develop an application that would send data via satellite if there is no LTE coverage but I don't see any relevant documentation regarding...
I am currently using the ble_app_template code from examples\ble_peripheral in SDK v10. The code and BLE read/write function successfully works. I now want to combine the...
When I publish messages to the mesh network via a Vendor Model, after connecting to device and performing a successful vendor command sequence, I start sending publishes of...
Helo, I am developing a BLE product, and @ encryption stage, I get thie message on the topic.
I attach my log for further information.
The log entry that gives the...
Hi. I am currently using an nRF52840 DK board and SDK 17.0.2.
I require 16-bit heart rate service UUID to work with a 128-bit vendor specified custom service.
When I create...
I have competed development on a project using the digikey sparkfun dev modules. I'm now entering production but my factory can not find a model on the market that works....
