Hi All,
I'm using nRF24L01P for TX device and want to receive packet from nRF51822 RX device.
nRF24L01P TX device Register settings are as follows;
Reg.EN_AA=0x00...
I am trying to develop for some nRF51822 mbed boards, and I would like to use the S130 SD to enable both central and peripheral behaviour. The machine I'm using for development...
I'm using the nRF51822 eval kit
I have installed MCP but after starting I get pop-up: Master Control Panel has stopped working
In nRFgo Studio / Device manager pane...
the proximity example is running ok. but when I modify the length of the alert_level I have the following error on the server side that I am not understanding.
476;16:12...
Hi all,
I'm working with the nrf51422 and the nrf51822 and I was wondering what the current status of the over the air DFU system is.
I'm using SDK 6.0 and I managed...
nRF24l01+ at a transmitter module one time successful transmission show & after 1 sec failed also . if any doing programming with atmega32 ,please send code for TX & RX ....
Hello,
can the radio notification and radio disable APIs be used to use the radio hardware from the application layer?
Background of my question is, that I have an application...
Hi,
We are in the process of adding an external GPS antenna to our board and following the guides in the documentation feels a bit risky since names for circuit board...
I tried to redefine weak app_error_fault_handler by custom one (nRF5 SDK for Thread and Zigbee v2.0.0, Segger Embedded Studio), according to https://infocenter.nordicsemi...
Hello, I am currently in the micro selection process for a project looking to go to production that requires the capturing of an image and the sending of that image over Bluetooth...
Small bug report: MAX and MIN are defined in param.h. nordic_common.h redefines these macros which creates warnings if param.h is also included. nordic_common.h should check...
Hi , everyone
i want nRF52840 to acts as central and peripheral simultaneously . how can i achieve this ? i have seen in website nRF52840 can concurrent upto 20 link (multilink...
Hi,
how to connect multiple peripheral to single central using app , i wan to send the data from central to multiple peripheral and peripheral will also want to send the...
Hi, I'm currently developping my first app in java.
This app requires a direct connection with my BL652, which doesn' t accept any kind of pairing option. That being said...
I'm migrating a project from SDK 14.2.0 to SDK 15.3.0. I use gcc. I have three advertising modes and the first of them is working fine. For the second one, the same
ble_advertising_init_t...
Hello,everyone
I want to add dfu service in UART example ,but when I tried to allocate the RAM,Debug terminal shows nothing,Then I set the breakpoint in nrf_sdh_ble.c and...
I am using Nordic SDK 15.3 and nRF52840 to interface to a NAND flash TC58CVG2S0HRAIG. I'm new with the SDK and I have little experience with the SPI / SPIM functions. I started...
Hi guys,
I use SDK14.2 (i can switch to SDK15.0 if it makes any differences) and would want to integrate FreeRTOS to my existing project. I have tried the FreeRTOS example...
