I'm running into issues when specifying non-secure for the build target, even for the basic Blinky sample. I created a build configuration with the nRF Connect SDK v3.4.0...
we have a 'long lived' tcp connection w/ regular data sends (1hz of 256 bytes for mqtt publishes) where sendmsg() sometimes returns EAGAIN. when trying again it usually works...
our current network provider says that they have a restriction on their sim profile so that the mtu should be less than 1430. however things like pdn_dynamic_params_get()...
nRF54L15: system clock stops permanently after a GRTC compare event is lost
Disclaimer
Claude Code (Opus 5) was used to assist with this investigation and with the drafting...
I am using the nRF9151-DK as an SPI slave . The SPI communication is not working as expected, and the nRF9151-DK is not receiving any data from the SPI master .
I have configured...
Hi,
Does the nRF54L15 support Direction Finding (AoA/AoD) and Channel Sounding together — i.e., can both features run on this specific chip, either simultaneously or at...
Hi,
We use the nRF9151 modem and need the following data from it: Mobile Country Code (MCC), Mobile Network Code (MNC), Tracking Area Code (TAC), cell_id and rsrp.
We...
An SPI port is configured as a master, and all the signals seem to operate correctly except the SPI_MOSI.
The configuration is shown below. When the spi_transceive_dt()...
Hi,
I was looking to buy passive components for NRF51822 QFAA. Bill of Materials states specific tolerance and dielectric which is very difficult to find so, can anyone suggest...
Hi,
We are unable to get the correct location (even approximate) using the nrfCloud API for Location based on Single-Cell. For the given "mcc", "mnc", "tac" and "eci" combination...
I'm running into issues when specifying non-secure for the build target, even for the basic Blinky sample. I created a build configuration with the nRF Connect SDK v3.4.0...
Hi,
We’re developing a BLE-based product on the nRF54L15 (InsightSIP ISP2454-LX) using nRF Connect SDK v3.0.2 , with MCUboot enabled for DFU.
Our BLE application is based...
we have a 'long lived' tcp connection w/ regular data sends (1hz of 256 bytes for mqtt publishes) where sendmsg() sometimes returns EAGAIN. when trying again it usually works...
our current network provider says that they have a restriction on their sim profile so that the mtu should be less than 1430. however things like pdn_dynamic_params_get()...
Updating nRF Connect for Desktop from 5.3.2 to 5.4.0 resulted in "flickering" UI effects.
The Docu still mentions support for Ubuntu 22.04, is that tested by simply starting...
nRF54L15: system clock stops permanently after a GRTC compare event is lost
Disclaimer
Claude Code (Opus 5) was used to assist with this investigation and with the drafting...
I am using an nrf7002dk and my external modules have arrived. The external modules are Minewsemi MS12SF1, which is a combo of nrf5340 and nrf7002.
To start, I wanted to...
Hi Nordic Support Team,
I have designed a custom board based on the nRF52840 and would appreciate it if you could review my schematic and PCB layout before I proceed with...
I am using SDK 2.7.0. When trying to install the CHIP tool, I get the error - view below.
I have tried everything - it seems that the OAuth client is hardcoded into the...
Dear Nordic team,
we are developing an application for a nRF9151 which will perform some HTTPS requests. For that purpose we want to encrypt and store an API key (string...
