My DECT nr+ PT supports connecting to either of a set of networks, which of course have different integrity and cipher keys.
While scanning for cluster beacons, I can receive...
Hello,
in cases where the LTE signal strength is extremely low, we observed that the LwM2M /4/0/2 RSRP rolls over from -128 to 127. We found that the nRF Connect SDK uses...
As part of the Bluetooth LE course we need to setup and install the nRF BLE sniffer for wireshark. I have followed the explained steps in the course to set up wireshark to...
The at command documentation says that ENVEVAL is only available in system mode 2 (CFUN=2). Is there a reason why the command can't be run in any other mode? For example if...
Hi
The TWI driver has a twi_clear_bus() function but the TWIM does not.
I'm getting an I2C error, and need to do I2C soft reset. I'm doing this manually at moment but...
Official Launch Video
Welcome to this 2 or 3-part blog about the nRF52 Rocket, a BLE-enabled model rocket, which you’ve just seen soaring through the air in the video above. In the first part of blog…
BLE is native supported on Android from v4.3. It has been continuously improved as Android evolving. It's getting more and more complex with additional features. It's important that a Bluetooth app should…
nRF-connect-Mesh PC tool allows the user to demonstrate the nRF OpenMesh and the Mesh Device Firmware Update (DFU).
The Mesh DFU will be used for nRF OpenMesh and the Bluetooth Mesh when it is made available…
Many developers might be familiar with the problems that may arise when wanting to measure current consumption, especially with applications using from a couple of µA to some mA. You most probably have…
This is a summary of a three part blogpost series at www.norwegiancreations.com
Introduction
We at Norwegian Creations work out of the coworking space DIGS in Trondheim. In our office, we have a coffee…
The ultra simple to use pxt editor for Microbit (https://pxt.microbit.org/) supports sending data using the nRF51822 radio. The tool supports using both BLE and proprietary protocols.
For this project…