I want to connect Waveshare E-ink display to nRF5340 using e-Paper Driver HAT. At first, I tried to make all the calls by my own, just by rewriting the code from the ESP driver...
Hi,
starting from ncs 3.2.0 (also in 3.2.1) when i attached the debugger (jlink ultra+, under VS code with nrf connect extension) to my nrf52833 board, i am getting the...
Hi, I'm struggling to setup an application on the nrf54l15dk to control the nrf9151dk SLM over UART.
I have done the Cellular IoT Course and successfully controlled the...
HI
My current system consists of an nRF54L15 paired with an external flash and sensor. In low-power mode, the current consumption is approximately 15 µA. After sleeping...
Is it possible to promote my project here: complete Zephyr development environment running solely on Raspberry Pi 4 Bookworm OS? If nothing else it does provide information...
Bluetooth LE is not a fast wireless protocol, transfer speeds are usually measured in single-digit to low tens of kilobytes per second. This is generally not an issue unless large amounts of data need…
PCB Design
Abstract:
The SkyenLab Bluetooth module was developed using the nrf51422 QFN48 QFAC reference design as well as help from the Nordic Semiconductor support portal and white papers. A proof…
Our Project
This post is to clarify team SkyenLab’s scope for satisfying the senior design class requirements and Nordic Semiconductor requirements during the first semester (Aug. 2015 - Dec. 2015) of…
TL;DR: It ignores whatever the computer tells it to do and does an automatic detection.
And the reason? UART terminals are not doing flow control settings in a consistent way, and in some cases incorrectly…
Introduction
A few months ago I started running again. Music helps me to stay motivated. Since most earphones keep falling out, especially when the sweat comes out, I googled for some sports earphones…
List of changes from µESB to nrf_esb
All functions, structs, enums and defines have been renamed from uesb_xxx to nrf_esb_xxx.
Events:
Events used to be triggered within radio interrupt context…