Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
MPU FAULT Instruction Access Violation on end node after publishing data when using nrf5340 as provisioner to set model publish address 0

The provisioner sample was used as the base code for adding the function to set model's publication address. After doing so the end node goes into Requesting Help regarding...
5 views

0 replies

Started 5 minutes ago
by Utkarsh
Not Answered
Inquiry Regarding PHY Configuration 0

The advertising PHY is set to 1M; is it fixed? If so, I'd like to understand the reason by reviewing the relevant technical documentation. In the example, it is set to AUTO...
24 views

0 replies

Started 4 hours ago
by giun.kim
Not Answered
nRF52840 - UARTE dropping 7th character 0

I'm essentially building a BLE to UART gateway to allow our microcontroller device to talk to our apps. The BLE section is the nRF52840 and I'm trying to simply use it to...
22 views

0 replies

Started 4 hours ago
by DarkMeans
Not Answered
Confirmation Question: Can MCUboot be made an immutable bootloader in the nRF52840 IC? 0

Hi, I am reading through different Nordic documentation. In some documentation, it shows a first stage B0 Nordic bootloader. This bootloader then can point to MCUboot...
24 views

0 replies

Started 6 hours ago
by Canadian_EE
Not Answered
Cannot run sample: Peripheral HIDS mouse on nRF52 Dongle 0

Hi, While I understand that the sample code is not intended for the nRF52 Dongle, I am still wondering if I can make it work on it. I have successfully tested it on...
21 views

0 replies

Started 6 hours ago
by TomX

Recent in Nordic blog

On nRF Connect for iOS & SIMD Optimizations in Swift

Dinesh Harjani

We released a small update late last week. It’s a follow-up to our last release of 2019, and like its predecessor, this release, 2.1.2, aims to improve the general stability of nRF Connect for iOS as well…
- 31 Jan 2020
Q&A for "Embedded Antennas for IoT" webinar

Petter Myhre

This blog post contains answers to questions asked during the "Embedded Antennas for IoT" webinar hosted by Nordic Semiconductor 17.10.2019. You can watch a recording of the webinar here. You…
- 22 Nov 2019
nRF Connect 2.1 for iOS: Welcoming Dark Mode

Dinesh Harjani

It has taken a lot longer than we previously thought, but we made it here, to our first big point release for nRF Connect 2.0. Throughout this “two-point-oh" journey, you’ve been an invaluable asset to…
- 19 Nov 2019

Latest guides

Software and Protocols: Automating nRF91 TLS credential management via serial port AT commands

Daniel Veilleux

I have spent a bit of time recently experimenting with different TLS credential configurations using nRF91-DKs. Eventually I got to the point where I wanted to do things like swap out the certificates…
- 10 Jan 2020
Getting started: nRF Connect for Cloud Certificate Update

Joakim

The content of this guide is now covered in the documentation on nrf Connect SDK documentation page.For the most up-to-date instruction to Update Cloud Certificate please follow this link.
- 27 Sep 2019
Getting started: Thingy:91 Firmware Update using MCUboot

Joakim

The nRF Connect Programmer application now also supports MCUboot! Follow these steps to update through the programmer application or the following guide for the command line alternative. This guide shows…
- 23 Sep 2019
Bluetooth low energy: Concurrent Advertising

Håvard

I have been asked several times about variations of the following advertising scenario, so I decided to make a blog post that I can refer to, and hope it might prove useful for others out there that are…
- 9 Sep 2019
Software and Protocols: The four kinds of data you need to consider when developing an IoT product

Markus Tacker (he/him)

In this post I will give you an introduction to the four kinds of data you need to consider when developing an IoT product: Device State Device Configuration Past Data Firmware Updates It's these …
- 9 Sep 2019
Getting Started : Automate building of HEX files for your nRF Connect SDK application using CircleCI or GitHub Actions

Markus Tacker (he/him)

Continuous delivery is in important aspect of short time to market and since the nRF9160 supports firmware over the air updates we want to ship a new firmware to our development boards every time we update…
- 14 Aug 2019