Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Linux USB ports 0

I have a nrf9160dk that drives a screen via SPI, using an IT8951 controller. The firmware driving the screen works fine if I plug the USB cable on a power bank or using MS...
9 views

0 replies

Started 4 hours ago
by amelio
Not Answered
9151 not able to read sim card 0

hi support team, customer is ordering sims from network supplier, and i got one sim card, but after testing i found this sim card can't be recognized. here is the modem...
9 views

0 replies

Started 13 hours ago
by William.wei
Not Answered
During the R&D phase, the testing of the Matter certification items failed 0

Hi， During the initial screening of Matter certification during the R&D phase, it was found that several test items did not pass the test. Could you please help investigate...
19 views

0 replies

Started 14 hours ago
by sean
Not Answered
nrf_pwr_mgmt_run(); is not executing in NRF52810 0

I’m working on an nRF52-based design where the device should remain in System ON low-power mode after an operation (SAADC sampling + BLE sync). After SAADC data collection...
21 views

0 replies

Started 1 day ago
by Tapan Nayak
Not Answered
FPROTECT for NRF54L10 0

I'm working with NRF54L10 module. I needed more mcuboot space so in pm_static.yml I allocated it 80kb. Before this FPROTECT was working but after I allocated 80kb, now FPROTECT...
22 views

0 replies

Started 1 day ago
by Amaan Singh

Recent in the DevZone Blog

Bluetooth pairing vulnerability

PaKa

The Bluetooth SIG released an errata for the 4.2 and 5.0 versions of Bluetooth specification on July 23rd relating to a potential vulnerability with the pairing procedures. For Bluetooth low energy; this…
- 27 Jul 2018
Getting Started with the Thingy:52 and GCC/GDB

Daniel Veilleux

The Thingy:52 IoT Sensor Kit is a fancy development board that combines the nRF52832 SoC, a handful of sensors and user interface components, and a rechargeable battery. Although the Thingy is available…
- 20 Jul 2018
Provision, configure and control Bluetooth mesh networks with nRF Mesh

Petter Myhre

nRF Mesh are open source libraries for building your own Android and iOS Bluetooth mesh apps. It is also the name of the apps demonstrating a subset of the capabilities of the libraries. Use them in test…
- 25 Jun 2018
nRF52832 Buttonless DFU Development Tutorial - GitHub

gamnes

This tutorial is valid as of 2018-06-06, updates to tools and SDKs might have been made since then. Please review the information on http://infocenter.nordicsemi.com/ to see if any updates have been made…
- 12 Jun 2018
Optimizing Power on nRF52 Designs

notsane0

As customers reach the end of their design cycle, their attention generally falls on power optimization, especially for battery powered designs. The following are hints for achieving the lowest possible…
- 30 May 2018
New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018