Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
nRF52832 (E0/E1) Bluetooth failure and device hanging 0

We have two nRF52832-QFAA E0 version devices; Bluetooth works on one, but on the other, it used to work but stopped working over time. Even though we upload the same code...
3 views

0 replies

Started 5 minutes ago
by CAN KANIK
Not Answered
Error in Angle of Arrival Calculation for Direction Finding 0

Hello We are using nRF5340 as our EVK with a 12 antenna array plate(4x4 with center 4 ones not being there). Our beacon uses nRF52833. We used Nordic's sample codes- ...
34 views

0 replies

Started 1 hour ago
by Shivani
Not Answered
Subject: MPSL ASSERT: 69, 108 and HardFault when using ESB (CONFIG_ESB_MPSL_TIMESLOT) with BLE dual connection and ZMS on NCS v3.3.0 / nRF54L10 0

Hi, I'm running NCS v3.3.0 on a Nordic nRF54L10 (nRF54L Series, Cortex-M33) with: - BLE peripheral role, max 2 connections (dual connected simultaneously) - ESB in CONFIG_ESB_MPSL_TIMESLOT...
30 views

0 replies

Started 1 hour ago
by Pang0
Not Answered
Problem with updatable MCUBoot + multi updatable images 0

Hello, I work on a zephyr project with updatable MCUBoot and two updatable images. This configuration ends up with an unbootable image. The reason is that the CONFIG_MCUBOOT_MCUBOOT_IMAGE_NUMBER...
27 views

0 replies

Started 3 hours ago
by tdfilip
Not Answered
How to update the app via app? 0

Hello Nordic, I am working on nRF52832 with SDK 17.1, using ESB, I previously used UART for DFU updates, but now I need to perform OTA updates via ESB. I noticed a macro...
- development
- software
- 2.4 ghz
- nrf52832
- esb
- dfu
28 views

0 replies

Started 4 hours ago
by Lurn_Z

Recent in the DevZone Blog

Provision, configure and control Bluetooth mesh networks with nRF Mesh

Petter Myhre

nRF Mesh are open source libraries for building your own Android and iOS Bluetooth mesh apps. It is also the name of the apps demonstrating a subset of the capabilities of the libraries. Use them in test…
- 25 Jun 2018
nRF52832 Buttonless DFU Development Tutorial - GitHub

gamnes

This tutorial is valid as of 2018-06-06, updates to tools and SDKs might have been made since then. Please review the information on http://infocenter.nordicsemi.com/ to see if any updates have been made…
- 12 Jun 2018
Optimizing Power on nRF52 Designs

notsane0

As customers reach the end of their design cycle, their attention generally falls on power optimization, especially for battery powered designs. The following are hints for achieving the lowest possible…
- 30 May 2018
New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018
Accurate State of Charge Measurements For Li-Ion Batteries Using a State of Charge vs Open Circuit Voltage Lookup Table

Bjørn Kvaale

We have had a few questions on the Nordic DevZone related to state of charge estimation of Li-Ion batteries when used in conjucture with an nrf52 DK. This blog post will show you how to customize your…
- 14 May 2018
Testing Long Range (Coded PHY) with Nordic solution (It Simply Works)

Susheel Nuguru

**Project and hex files for testing this is attached in the end of this blog. Introduction There has been a lot of discussion/testing/confusion about testing the long range feature of Bluetooth Low Energy…
- 2 May 2018