Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
case about nRF5340 DFU 0

Hi, 1.In ncs v3.0.0, can both USB DFU and UART DFU be enabled simultaneously on the nRF5340 DK board? 2. If USB and UART DFU can be enabled simultaneously, then how should...
2 views

0 replies

Started 5 minutes ago
by peter.min
Not Answered
Matter 1.4.0 support 0

Hello, My SDK is NCS2.8.0, I want to know the version of matter, but I can't find it, may I know how to get? BTW, does NCS SDK support Matter 1.4.0, if yes, could you tell...
10 views

0 replies

Started 12 minutes ago
by susepc
Not Answered
BT NUS logging corruption 0

In our development using NCS-2.6.1 it is desirable to have logs using BT NUS. "Serial Bluetooth Terminal" android application is used. Logs are having corruption. Looks...
6 views

0 replies

Started 22 minutes ago
by iivanov
Not Answered
NRF TERMINAL IN VSC 0

Hi: I'm doing the exercise L3-E1. I used nRF Connect SDK Toolchain v2.7.0 because it didn't work with v2.8.0 How do I make NRF Terminal appear? Thanks and Best...
18 views

0 replies

Started 6 hours ago
by Luiz Miranda
Not Answered
GATT characteristics handle customization 0

Hello, We are working on establishing a connection between one of our existing Bluetooth modules (cypress) and nordic based module to provide backward compatibility with...
23 views

0 replies

Started 10 hours ago
by SiddhantG

Recent in Nordic blog

nRF51822 now supports extended industrial temp range (-40 – 105C)

Pär H

We recently announced that we now support “extended industrial temperature range” (-40 – 105C) on our nRF51822. The devices supporting -40 - 105C are the QFAA (QFN with 256kB flash and 16kB RAM) and the…
- 24 Aug 2015
Running micro-ESB concurrently with BLE

Audun

Introduction Using proprietary protocols can be an effective way of addressing shortcomings in BLE. When communicating between two nRF chips, one can for example use a different packet format or different…
- 14 Aug 2015
FruityMesh open sourced - Connection based meshing that will run on batteries

Marius Heil

Hello everybody, I have just published the sourcecode of FruityMesh on GitHub. It is a meshing algorithm that uses standard BLE connections. Plug in as many nodes as you like and they will automatically…
- 12 Aug 2015
Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015