Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Using NodeJS libraries on Linux to talk to Nordic BLE devices 0

I am interested in writing a BLE central that reads data from multiple BLE Nordic sensors. The BLE central will be running on Embedded Linux which uses the BlueZ stack. ...
- bluetooth low energy
1238 views

0 replies

Started over 10 years ago
by helpme
Not Answered
S110 8.0.0 and RIOT 0

Hi, I'm trying to get S110 softdevice (v8.0.0) working with RIOT. I had some issues (I couldn't initialize TIMER1 or TIMER2 until softdevice is setup & enabled) but I think...
- s110
- riot
- nrf51822
854 views

0 replies

Started over 10 years ago
by pixiedust
Not Answered
iBeacon usage as pairing less UART extender 0

Hello everyone, I got a task which I try to implement using a NRF51822 iBeacon board. The Task: Advertise a Device and provide a mechanism to connect without traditional...
985 views

0 replies

Started over 10 years ago
by pk
Not Answered
MPU6000 SPI 0

Hello, I'm working with the EK PCA10003, that has the NRF51422. I'm trying to read the information of the accelerometer MPU6000 with an ISP interface. At the moment I cannot...
- nrf42522
- mpu6000 accelerometer spi
1365 views

0 replies

Started over 10 years ago
by Josue
Not Answered
nRF51 Bluetooth Smart GATT/GAP Driver for Linux ARM? 0

I'd like to use the GATT/GAP driver from an ARM based Linux system. Is there any possibility of getting a library compiled for ARM or (cough) the source code to build it myself...
- nrf51822 embedded linux
542 views

0 replies

Started over 10 years ago
by Erik Sanchez

Recent in Nordic blog

Provision, configure and control Bluetooth mesh networks with nRF Mesh

Petter Myhre

nRF Mesh are open source libraries for building your own Android and iOS Bluetooth mesh apps. It is also the name of the apps demonstrating a subset of the capabilities of the libraries. Use them in test…
- 25 Jun 2018
nRF52832 Buttonless DFU Development Tutorial - GitHub

gamnes

This tutorial is valid as of 2018-06-06, updates to tools and SDKs might have been made since then. Please review the information on http://infocenter.nordicsemi.com/ to see if any updates have been made…
- 12 Jun 2018
Optimizing Power on nRF52 Designs

notsane0

As customers reach the end of their design cycle, their attention generally falls on power optimization, especially for battery powered designs. The following are hints for achieving the lowest possible…
- 30 May 2018
New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018
Accurate State of Charge Measurements For Li-Ion Batteries Using a State of Charge vs Open Circuit Voltage Lookup Table

Bjørn Kvaale

We have had a few questions on the Nordic DevZone related to state of charge estimation of Li-Ion batteries when used in conjucture with an nrf52 DK. This blog post will show you how to customize your…
- 14 May 2018
Testing Long Range (Coded PHY) with Nordic solution (It Simply Works)

Susheel Nuguru

**Project and hex files for testing this is attached in the end of this blog. Introduction There has been a lot of discussion/testing/confusion about testing the long range feature of Bluetooth Low Energy…
- 2 May 2018