Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
related to threads 0

Hi all, i want to establish connection between two threads in cmsis-rtos, can i use 1) semaphore to do this? 2)message queue should be used or any other ipcs can be...
899 views

0 replies

Started over 10 years ago
by renu
Not Answered

Data transfer rate by serialization 0

Hi, I have two CPU in our product. (STM32F2 and Nordic nrf51422). I use serialization function to link those two CPU(refer to ble_s110_serialization sample) But I find...

715 views

0 replies

Started over 10 years ago
by Elliot.Chao
Not Answered

Can't connect directly after I exit our app by back key on phone 0

Hi, My behavior is as follows Turn on my device(use 51422) and advertising(2 Service and 3 Characteristic) Turn on my cell phone(Samsung Note3),scan my device...

513 views

0 replies

Started over 10 years ago
by Elliot.Chao
Not Answered

Why do I use twi_hw_master.c can run on 2.4G, Bluetooth can not? 0

Hello: I used analog IIC write MPU6050. Again after power download programs, mpu6050 can run up there ACK response. But the debug will not run. Simulation IIC because no...

1113 views

0 replies

Started over 10 years ago
by bugg
Not Answered
nRF51822 and nRF24L01+ 0

Hello! How can I communicate with my nRF24L01+ and nRF51822 at the same time. I can set up same channel, CRC-mode and I don't use ESB. But what about address? How do I set...
- nrf51822 nrf24l01+ addre
808 views

0 replies

Started over 10 years ago
by Schuebbe

Recent in Nordic blog

Optimizing Power on nRF52 Designs

notsane0

As customers reach the end of their design cycle, their attention generally falls on power optimization, especially for battery powered designs. The following are hints for achieving the lowest possible…
- 30 May 2018
New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018
Accurate State of Charge Measurements For Li-Ion Batteries Using a State of Charge vs Open Circuit Voltage Lookup Table

Bjørn Kvaale

We have had a few questions on the Nordic DevZone related to state of charge estimation of Li-Ion batteries when used in conjucture with an nrf52 DK. This blog post will show you how to customize your…
- 14 May 2018
Testing Long Range (Coded PHY) with Nordic solution (It Simply Works)

Susheel Nuguru

**Project and hex files for testing this is attached in the end of this blog. Introduction There has been a lot of discussion/testing/confusion about testing the long range feature of Bluetooth Low Energy…
- 2 May 2018
Introducing experimental release of Programmer Application

Reidar Martin Svendsen

nRF Connect for desktop has proven its flexibility by being cross platform and ability to install and update applications based on users need. Motivation Our initial goal was to modernize and cover…
- 30 Apr 2018
New in nRF5 SDK v15: Strong Hardware-Based Security with Infineon OPTIGA Trust X

ChristianLesjak

Defining a business model and implementing a technical infrastructure are two major phases in building a successful product or IoT system. However, protecting the business model and your customer’s data…
- 9 Apr 2018