Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
We are currently looking for an Embedded / nRF Developer in Stuttgart that will help us to further develop FruityMesh (https://github.com/mwaylabs/fruitymesh) and our commercial Product BlueRange…
The purpose of this tutorial is to expound my notes on the studies I have done on the use of nRF51, but also serve for the nRF52, and thus share with the beginner as I of the Portuguese language. This…
This tutorial aims to help Portuguese language beginners, like me, with the nRF5x family and who chose to use Eclipse as a development tool.
The tutorial will be very simple and we will use the Eclipse…
nRF51 Low power modes and power profiles documentation
The low power modes for the nRF51 series are System On and System Off. You can read about them in the nRF51 Series Reference Manual v3.0 sections…
###Note: This tutorial is for the legacy DFU module included in SDK version 11 and earlier. To get started with the new DFU included in SDK 12 and above, please see the SDK documentation in the Infocenter…
Before we begin
Table of context
Before we begin
The "Hello world" example
Advertising
RSSI
Addresses
Address types
Advertising types
Bonding
Advertising data
Scan response data
Change Log 2018…