Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Power Profiler Kit II Firmware Source 0

Hi everyone, I’ve been using the Power Profiler Kit II (PPK2) and was wondering if the firmware source code is publicly available, or if there are any plans to publish it...
22 views

0 replies

Started 15 hours ago
by Matthias Sokolowski
Not Answered
LIS2DH12 Sample Not Working on nRF54L15-DK — "Device LIS2DH is not ready" 0

Hi everyone, I'm trying to get the LIS2DH12 sensor sample working with the nRF54L15-DK , but I'm running into an issue where the device doesn't seem to initialize properly...
27 views

0 replies

Started 17 hours ago
by DennisDG
Not Answered
Dynamic BLE TX Power Config Fails (nRF5340-DK) 0

Hello everyone, I’m working on a project using two nRF5340-DK boards to measure throughput and RSSI while dynamically changing the PHY and TX power. I started from the official...
33 views

0 replies

Started 19 hours ago
by diegonovo02
Not Answered
Power profiler Kit II for NRF54L15 0

Hi, When i want to connect my Power profiler kit II to my laptop, it first blinks GREEN. After i connect to it using the power profiler app, it goes: RED -> AMP (Ampere...
29 views

0 replies

Started 22 hours ago
by NickDeLeenheer
Not Answered
How to configure a custom nrf5340 board with HV and DC-DC and a VREGH 3.0V output 0

I have a custom board with a nRF5340 and need to configure VREGH in DC-DC mode and set 3.0V output on it. I see the documentation on REGULATORS — Regulator control where...
31 views

0 replies

Started 22 hours ago
by lcj

Recent in Nordic blog

Provision, configure and control Bluetooth mesh networks with nRF Mesh

Petter Myhre

nRF Mesh are open source libraries for building your own Android and iOS Bluetooth mesh apps. It is also the name of the apps demonstrating a subset of the capabilities of the libraries. Use them in test…
- 25 Jun 2018
nRF52832 Buttonless DFU Development Tutorial - GitHub

gamnes

This tutorial is valid as of 2018-06-06, updates to tools and SDKs might have been made since then. Please review the information on http://infocenter.nordicsemi.com/ to see if any updates have been made…
- 12 Jun 2018
Optimizing Power on nRF52 Designs

notsane0

As customers reach the end of their design cycle, their attention generally falls on power optimization, especially for battery powered designs. The following are hints for achieving the lowest possible…
- 30 May 2018
New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018
Accurate State of Charge Measurements For Li-Ion Batteries Using a State of Charge vs Open Circuit Voltage Lookup Table

Bjørn Kvaale

We have had a few questions on the Nordic DevZone related to state of charge estimation of Li-Ion batteries when used in conjucture with an nrf52 DK. This blog post will show you how to customize your…
- 14 May 2018
Testing Long Range (Coded PHY) with Nordic solution (It Simply Works)

Susheel Nuguru

**Project and hex files for testing this is attached in the end of this blog. Introduction There has been a lot of discussion/testing/confusion about testing the long range feature of Bluetooth Low Energy…
- 2 May 2018