Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Custom Sensor Driver for CT1711 Temperature Sensor 0

I am trying to create a custom sensor for CT1711 temperature sensor. I have created the sensor driver code and device tree binding, but it won't start (initialize) and the...
- development
- software
- zephyr
- nrf52832
41 views

0 replies

Started 1 day ago
by nanangcreacoll
Not Answered
NRF Cloud Shadow Update / AT Command messaging delay 0

Hi, Is it possible to make the MQTT connected device receive the Shadow config updates and AT Commands immediately? Based from our testing, the device only receives the...
51 views

0 replies

Started 2 days ago
by AdrianT
Not Answered
Regarding I and Q measurements on the nRF54L15 development kits 0

Hi Nordic Support Team, I'm currently experimenting with Channel Sounding using a couple of nRF54L15 boards. I am trying to obtain raw I and Q samples so that I may analyze...
92 views

0 replies

Started 3 days ago
by ignatious-p
Not Answered
Matter + OpenThread + PSA (Oberon): Crypto/Memory Optimization + mbedTLS Logging 0

Hello, currently i am configuring the networking stack on my project. The goal is to use Matter's built-in Thread connection, to establish a Secure CoAP connection. I...
53 views

0 replies

Started 3 days ago
by jlux
Not Answered
Android 15 introduces bug where bonded devices cannot be disconnected 0

We use several Nordic chips in our BLE sensors. We bond to the devices from Android, connect to update configurations, then disconnect such that the device then advertises...
90 views

0 replies

Started 13 days ago
by RickW

Recent in Nordic blog

Provision, configure and control Bluetooth mesh networks with nRF Mesh

Petter Myhre

nRF Mesh are open source libraries for building your own Android and iOS Bluetooth mesh apps. It is also the name of the apps demonstrating a subset of the capabilities of the libraries. Use them in test…
- 25 Jun 2018
nRF52832 Buttonless DFU Development Tutorial - GitHub

gamnes

This tutorial is valid as of 2018-06-06, updates to tools and SDKs might have been made since then. Please review the information on http://infocenter.nordicsemi.com/ to see if any updates have been made…
- 12 Jun 2018
Optimizing Power on nRF52 Designs

notsane0

As customers reach the end of their design cycle, their attention generally falls on power optimization, especially for battery powered designs. The following are hints for achieving the lowest possible…
- 30 May 2018
New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018
Accurate State of Charge Measurements For Li-Ion Batteries Using a State of Charge vs Open Circuit Voltage Lookup Table

Bjørn Kvaale

We have had a few questions on the Nordic DevZone related to state of charge estimation of Li-Ion batteries when used in conjucture with an nrf52 DK. This blog post will show you how to customize your…
- 14 May 2018
Testing Long Range (Coded PHY) with Nordic solution (It Simply Works)

Susheel Nuguru

**Project and hex files for testing this is attached in the end of this blog. Introduction There has been a lot of discussion/testing/confusion about testing the long range feature of Bluetooth Low Energy…
- 2 May 2018