I WANT COMMUNICATION BETWEEN A NRF51422 AND NRF528321 BOARDS, IN WHICH IN NRF51422 BOARD I WILL MEASURE PWM COUNT(IT IS PHERIPHERAL) AND SEND IT TO NRF528321 BOARD WHICH IS...
Hi,
I've been working on a way to detect and prevent replay attacks when beacons are used for sensor data. This is mostly used for home automation sensors, where I have BLE...
Hi,
For our current application we have migrated from SDK 13 to SDK 14. We are using RTOS to handle the functionalities of our application. We replaced our own task for handling...
hello,
I use nrf51822 + S130 + SDK12.2 in my product, nrf51822 work at central + peripheral mode,and i use nrf_duf_flash module for my dfu funtion.
The problem is, i...
I want to communicate Central and peripheral devices with KeyPass. Also I want to generate keypass in Peripheral device. But keypass should to include symbols, low/upper case...
This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later.
Start Visual Studio and begin creating a new…
In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4
network.
The tunnel broker is providing IP conversion service with 6in4.
Preparation
Raspberry Pi…
The GNU Debugger (GDB) is a popular tool that provides familiar features like breakpoints along with a command syntax that allows creativity in the debugging process. Although its command line interface…
2020-08-04: The content of this guide is now covered in the documentation on Infocenter. For the most up-to-date Getting started guide with nRF9160 DK please follow this link.
2020-03-09: Updated tutorial to…
The scope of this tutorial is to make it clear how a developer can adjust the RAM and FLASH memory start addresses. The examples demonstrated in this tutorial uses SDK 15.2 The first three Sections explains…
This tutorial demonstrates how to adapt and program SDK example applications to the nRF52840 dongle using USB DFU. It also describes how to program the dongle via Serial Wire Debug (SWD) using an external…
We are happy to announce our first release of the nRF Connect for Cloud Device API!
Connect your BLE, LTE/NB-IoT or any other device to our free IoT development platform and interact with that device through…
This is a follow-up to my previous blog post; adding custom commands to a BLE example.
I hope it was interesting to see an example of adding the vendor specific Nordic UART service (NUS) into another…