Hi all,
I am making a device which involves using nfr52832(PCA10040) to communicate with a NAND flash through spi to store data acquired from the ADC. After all the data...
How to enable semihosting in sdk11 examples?
This works, but I can't port it to examples/periferal/template_project :(
changes:
pca10028/armgcc/Makefile:
adding...
Hello,
I want to store temperature samples in flash of nrf51822. I am using pca10028 and sdk 12.2.0.
I have the code for writing,deleting and reading from flash memory....
Hello,
I have a question about stack usage. I use nRF51822 SoC, 12.2 SDK & IAR 7.60.1. I am interested in stack usage. Have you done any estimations? Or may be you have...
This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later.
Start Visual Studio and begin creating a new…
In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4
network.
The tunnel broker is providing IP conversion service with 6in4.
Preparation
Raspberry Pi…
The GNU Debugger (GDB) is a popular tool that provides familiar features like breakpoints along with a command syntax that allows creativity in the debugging process. Although its command line interface…
2020-08-04: The content of this guide is now covered in the documentation on Infocenter. For the most up-to-date Getting started guide with nRF9160 DK please follow this link.
2020-03-09: Updated tutorial to…
The scope of this tutorial is to make it clear how a developer can adjust the RAM and FLASH memory start addresses. The examples demonstrated in this tutorial uses SDK 15.2 The first three Sections explains…
This tutorial demonstrates how to adapt and program SDK example applications to the nRF52840 dongle using USB DFU. It also describes how to program the dongle via Serial Wire Debug (SWD) using an external…
We are happy to announce our first release of the nRF Connect for Cloud Device API!
Connect your BLE, LTE/NB-IoT or any other device to our free IoT development platform and interact with that device through…
This is a follow-up to my previous blog post; adding custom commands to a BLE example.
I hope it was interesting to see an example of adding the vendor specific Nordic UART service (NUS) into another…