ble current consumption on connected mode

[Mohamed O.Abouzeid]

hello everybody,

I measured the current consumption in two cases : in the advertising mode the current is around 4 ~ 5uA, & in the connected mode, the current is 160 uA , I think the current in this case is very high , I expected it to be minimum than this, I'm asking about if there is any possibility to minimize the current in that case or not ? ?

I read on the datasheet that the Arm processor consumes around 150 uA besides the system current, so if this is correct, then we'll have an offset current equals to 150uA besides the system current, what do you see? ?

[Mohamed O.Abouzeid]

@Aryan yes, & it was 5mA only when the command controls leds is handled, any other services events don't increase the current to such level, I remeasured the current consumption on the connected mode, it was 35 uA & while bonding it was 380 uA, which is good for my application, but 5mA is very high ....