Hello,
When we flash the BLE Zephyr project to the external chip (nRF52833), do we need to add the SoftDevice controller .hex file as well, or does the merged .hex file include everything necessary?
Thank you.
Hello,
When we flash the BLE Zephyr project to the external chip (nRF52833), do we need to add the SoftDevice controller .hex file as well, or does the merged .hex file include everything necessary?
Thank you.
Hello,
There is a duplicate case (+) nrf_52833 External chip flashing - Nordic Q&A - Nordic DevZone - Nordic DevZone (nordicsemi.com) where I have been working on. I can close that one as you have uploaded the schematic here. I will give you a review lately.
Thanks.
BR
Kazi
Hello,
Yes.
OK Thank you
Best regards,
Madusha Fernando
Hello,
Yes.
OK Thank you
Best regards,
Madusha Fernando
Hello Madusha,
''Yes I provided external power. Please find the attached Image
Power supply = DIGILENT
Custom nrf chip = NRF52833-CJAA-B-R7''
It looks from the picture attached that you programmed your custom board by DK. The voltage supported by external debugging/programming is VDD voltage. Normally, this is 3 V when running from USB is the voltage level for custom board is as same as the voltage of DK?
I can not see any schematic here. Could you please upload your schematic file?
Thanks.
BR
Kazi
Hello,
Please find the schematic and Part Number document.
Kindly check the schematic of the custom PCB and give your advice