• State Verified Answer
  • Replies 3 replies
  • Subscribers 68 subscribers
  • Views 2990 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 100307
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

nRF51822, max IO pin voltage while off?

Frank Zhao

To be more detailed:

One of my ADC pins will be connected to another device that could be providing a voltage of about 3V, but through a 100 kohm resistor. (actually it's 6V, with two 100 kohm resistors as a divider)

While the nRF chip's VDD is completely off, the other device will not be off.

Is this safe long term? I don't want to leak any current.

If it is unsafe, I have another solution that will cost two extra MOSFETs, but I'd rather save money.

Thanks

  • 0

    As you can see in table 13 of the PS, doing this would violate the specification, since the I/O pin voltage would be above VDD+0.3 V (VDD being 0 in your case, but the I/O being 3 V). The exact effect of this is unknown, but this is not something I'd recommend you to test.

    Depending on your application, I would consider to leave the nRF51822 continously powered, but just set it in system off when not needed, not actually turn it off. If you do, and have VDD > 2.7 V, you are also allowed to have 3 V on a pin all the time. The chip is supposed to consume < 1 µA in this mode, but due to a PAN, current revisions might consume more. This will be fixed in the upcoming revision.

  • 0

    Thanks for the answer

    From what I've seen with other brands and architectures, leaking power into a pin while the power is off could potentially cause the current to leak into VDD via internal clamping diodes on the pin (or ESD protection diodes). Some low power CPU can actually start executing code if no brownout protection is implemented.

    I have edited my design to use a open drain design instead

  • 0 in reply to Frank Zhao

    Yes, powering the chip through a GPIO will most likely be possible on the nRF51822, so this should be avoided.

    If you found my answer useful however, I'd be happy if you could click the "Accept as answer" button below it, to mark this question as resolved. :-)

Related