UART example with light switch client error

[Arij]

Hi,

I merged UART example from nrf5 sdk v14.2 with light switch client example from mesh sdk v1.0.1, i have 2 boards client board which is nrf52832 and server board which is a custom board 

when i debug light switch client, it stucks, as shown below 

Any help please 

Best regards,

A.

[tesc]

Hi,

What I see from the screenshot is that the example is running. In what way is it stuck?

Regards,
Terje

[Arij]

Debugging stops in line 546 ERROR CHECK and the client board doesn't send anything

[tesc]

Hi,

In that case, the code should end up in app_error_handler() in nrf_mesh_sdk.c. Can you try setting a breakpoint in that function, and see what the error_code is? (Also, line_number and filename would be useful as that will confirm that the error happens on that exact location.)

Regards,
Terje

[Arij]

Now i have this 

and in nRFgo studio i don't see any softdevice region, the light switch example uses softdevice but uart example doesn't, i don't know where is the problem? please help me 

[tesc]

Hi,

I am very sorry for not getting back to you earlier.

I do not know if you found a solution, but in any case I would advise you to use nRF5 SDK for Mesh v2.0.1, as that version is qualified with the Bluetooth SIG. It is also easier to combine Mesh and non-mesh SDK in that version, see Coexistence with nRF5 SDK BLE functionality.

If you still want to stick to v1.0.1 (not recommended) then we do have a couple of examples where ble_app_uart is mixed with mesh, in the How to add mesh into nRF4 SDK v14.1 BLE application thread. It may be better using that as a starting point.

Regards,
Terje

[Arij]

Hi,

I ended up merging UART example with mesh sdk by adding UART modules and modified falsh_placement.xml file so it finally works. 

But now i'm facing another problem that i posted in This case, I found out that configuration of the server doesn't happen, and i don't see any log concerning the configuration of the node. however the switch on and off of the server works, i'm confused, 

I'm using mesh SDK v1.0.1 because i don't have enough boards for the mesh SDK v2.0.1.

Could you please help me on that?

Thank you,

[tesc]

Hi,

I see that another Application Engineer is monitoring that thread, so I think you should be good. I may decide to weigh in on it later but for now I think that thread looks fine.

Regards,
Terje