nRF52840 dongle installation

[Baruch]

Installing nRF52840 dongle on W10 PC. Please see the attached screenshot to help me out installing it for nRF Connect.

Thanks.

[Baruch]

This issue has resolved for itself without ANY changes from my side, which is not that good because it may stop working the same way it started...

FYI: I didn't reboot my PC. I removed this dongle and a few hours later plugged it back in. I did the same when it didn't work as well but nothing happened. 

You can see the same sn.

[Bjørn Kvaale]

Which version of the dongle do you currently have? You can check this by reading the line underneath PCA10059 on the white sticker on the back of the dongle (e.g. version 0.6.0). Were you ever asked to update the connectivity FW on the dongle (like shown below)?

[Baruch]

When should I press CTRL+R?  Could you please be more specific and describe step by step what I need to do to avoid any misunderstanding.

Thanks.

[Bjørn Kvaale]

Sorry. Open the ble app on nrf connect for pc, attach the dongle to the computer usb port, try to connect to the dongle & when you receive the error, press Ctrl + r to reload nRF Connect. This error is talked about here & will be fixed in the next release of nRF Connect for Desktop, which should be out end of next week.

[Bjørn Kvaale]

Try to reconnect to the dongle once the ble app is reloaded.

[Baruch]

Didn't help

[Baruch]

[Bjørn Kvaale]

In your device manager screenshot, it seems you are still in the standard view. Could you please try to press on the View tab -> Devices by connection & find the usb dongle like in my screenshot below. When the dongle is not in DFU mode (i.e. no blinking red light), you should have a DFU Trigger & USB CDC ACM available under the dongle USB Composite device. If you cannot see this, I would recommend installing the libusb driver via Zadig (see this user guide for help).

[Baruch]

At this moment it has started to work by itself again. No action has been taken, the system was NOT rebooted. :(

[Bjørn Kvaale]

I have mentioned this internally. Do you have any other pc you could try to get the dongle working on? If so, does everything work on that pc?

[Baruch]

It kind of doesn't make sense trying to change anything while it is working. At least for now. During the weekend I'll most likely install my new DK and new dongle on my home PC with W8.1

[Bjørn Kvaale]

Hopefully everything works fine on your home pc. There is a new update for nRF Connect for Desktop. I would recommend upgrading to version 2.5.0.