Tracedata

[Pema]

Hi,

I wonder if all Tracedata[n] pins are needed for debug? That would make five IO:s useless for other functions. Or is it possible to use 1-bit mode or something similar? If that is possible, are there any limitations other than data speed?

[ovrebekk]

Hi Peter

For regular debugging you only need the SWD pins (SWDIO and SWDCLK), and you are free to use the trace pins for other purposes. 

The Tracedata pins are only required if you want to do a full instruction trace during debugging, but this requires dedicated trace hardware to use (the Segger chip on the development kits are not set up for this). 

Best regards
Torbjørn

[Pema]

Hi,

We have dedicated trace hardware for this. But for trace functionality, do you need all five signals or does it work with a subset (like clk plus one or two of the tracedata pins)? I want to fulfill the needs of our sw guys, while not letting them occupy too many IO:s... If a subset works, what are the limitations compared with using all tracedata? Speed I guess?

[ovrebekk]

Hi Peter

For full ETM trace you need all the pins unfortunately. 

With a single data pin you only get ITM, which is not sufficient if you want to do live instruction trace. 

Best regards
Torbjørn

[Örjan]

Breaking in with a related question: We are doing instruction trace debugging on nrf52840 with the Segger j-trace module / ozon using the four tracepins + clk. From what we are able to see, only the cpu instructions are traced. We would need also to see traces for memory accesses, i.e address and data info. Are we doing something wrong/looking at the wrong place or is this simply not supported?

[ovrebekk]

Hi 

I will have to check this with Segger directly. As soon as I hear from them I will update the case. 

Best regards
Torbjørn