• State Verified Answer
  • Locked Locked
  • Replies 3 replies
  • Subscribers 74 subscribers
  • Views 936 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 270361
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Unable to run BLE samle on my nRF52840 dongle using nrf connect desktop application

nagesh.shamnur

i have nRF52840 Dongle (PCA10059) and when i connected the dongle and opened nrf connect SDK application and tried to run BLE, then i am getting the following error. Kindly let me know how to fix this issue. Thanks.

"ERROR Failed to setup device: Error message for known response code from DFU target: Opcode unknown or not supported."

""

Note: i have pressed the reset button so that my dongle so that it enters DFU mode and red LED is blinking.

Parents
  • 0

    Hi Nagesh

    Do you get the prompt that the "Device must be programmed, do you want to proceed?" Here you need to press Yes in order to proceed, as that is how you flash the device with the BLE connectivity firmware used to communicate with the nRFConnect BLE app.If you decline this, you won't be able to start the BLE app.

    Best regards,

    Simon

Reply
  • 0

    Hi Nagesh

    Do you get the prompt that the "Device must be programmed, do you want to proceed?" Here you need to press Yes in order to proceed, as that is how you flash the device with the BLE connectivity firmware used to communicate with the nRFConnect BLE app.If you decline this, you won't be able to start the BLE app.

    Best regards,

    Simon

Children
Related
Terms of service