Questions regarding CONEVAL

[ced27]

Hi team,

i first of all want to thank you, for your support and help so far.

I have some questions regarding the values that are been given by the AT command %CONEVAL:

1. How are the values been measured?

2. How do they depend on each other?

3. Which of these values depend on the network quality?

4. Which of these values can i manually affect?

5. How do they affect the current consumption of the device (nrf9160 DK)?

I hope my questions are not too confusingly asked

Best regards,

Cedric

[Øyvind]

Hi Cedric,

Which of these values can i manually affect?

None, of these can be affected by application. Most of the values in the %CONEVAL are network supplied, and RSRP, RSPQ and SNR are calculated in modem based on provided values. 

5. How do they affect the current consumption of the device (nrf9160 DK)?

There are many variables that impacts the current consumption e.g. TX  power, signal strength, among others.

I'm afraid based on these answers your other questions are no longer valid.

Kind regards,
Øyvind 

[ced27]

Hi Oyvind,

thanks for your respond.

Øyvind said:

There are many variables that impacts the current consumption e.g. TX  power, signal strength, among others.

And in what ways do they affect the energy consumption or what correlation do they have with the energy consumption?

For example if the value of tx_power increase what happen to the energy consumption, does it increase or decrease?

Best regards,

Cedric

[Øyvind]

Higher TX power increases the energy consumption. The same goes for low signal strength. 

-Øyvind

[ced27]

Hi Oyvind,

thanks once again for your response.

I made a table of the variables, whose values are likely to change, when the AT command %CONEVAL is been used periodically.

Can you please take a look at the table and help me out? I will really appreciate

Energy consumption.xlsx

Best regards,

Cedric

[Øyvind]

It's a little more complicated describing the values provided by network and the results of %CONEVAL.  

What are your intensions of the %CONEVAL usage? 

Please have a look at the following webinars: 

1. How to power optimize with the latest features in the nRF9160 SiP
2. Exciting new features in nRF9160 modem firmware v1.3.0

And then have a look at our Online Power Profiler for nRF91

Kind regards,
Øyvind

[ced27]

Øyvind said:

What are your intensions of the %CONEVAL usage? 

 I want to use the values from %CONEVAL to determine the energy efficiency/ energy consumption estimation of data transmission before actual data transmission has started

Is it possible?