Hi,
I am using nordic52840 dk board.
And i want to flash a bin file using nrfjprog command line.
For Hex file i am using below command
nrfjprog --reset --program blinky_pca10056.hex --family NRF52
But what changes requires to flash .bin instead of .hex file.
Regards
Hi,
Thanks for reply. but i can see on the help command that it support for .bin format as well.
I attached that image below
Yes i tried it. but didn't work for me as well.
I have the new version of nrfjprog.
And in the previous answer you mentioned the link to convert bin to hex file.
arm-none-eabi-objcopy -I binary -O ihex filename.bin filename.hexby using this command.
So my question is where i need to run this command "arm-none-eabi-objcopy"...?
or Do i need to install something for this.
because i simply try it to run in command line only where i used to run nrfjprog commands.
Correct me if the way i am doing is not correct!
Regards
Rohit Saini
Hmm. I also see that it doesn't work using v 10.15.2 external. I'll look into this internally.
But what compiler do you use if it doesn't provide a .hex file?
arm-none-eabi is part of GCC (not nrfjprog). If you have it installed on your computer, you will probably find it in:
C:\Program files (x86)\GNU Tools ARM Embedded\<version>\bin\arm-none-eabi-objcopy.exe
Make sure to add the path, wich in my case is "C:\Program Files (x86)\GNU Tools ARM Embedded\9 2019-q4-major\" to path:
Best regards,
Edvin
Ok, so I got to test this today. Using the objcopy tool from armgcc 9 2019-q4-major I could convert the bin file to a hex file. I then programmed that generated hex file, and it worked as expected:
I have reported the issue with --program .bin files internally to our nRF Command Line tools team. Thank you for reporting this.
Best regards,
Edvin
