Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hello!
So I can connect, disconnect and write to my applications characteristics via a PyQt5 GUI I threw together. On the python backend, I use Bleak to
search for devices...
I'm getting ERROR 12 upon calling ble_advertising_init. I understand that this is caused by exceeding the advertising packet max payload of 31 bytes. What options do I have...
Hi All,
I am testing the performance of a Relay Node in a mesh network.However it seems don't work.
I would like to show that the Relay node operation such as Rx and Re...
I am working on nRF52832 platform and my version of softDrive is (nRF5_SDK_15.3.0_59ac345), I am wondering in my application what is the data packet length and can Increase...
I have flashed my Thingy:91 via the nRF9160 DK using the Programmer with the pre-built at_client software, but I am unable to get any AT response when I connect using the...
Hi,
I'm using SDK v15.3.0 which has s132 6.1.1 to program an nRF521832. I had a single custom service on my stack and that was working well. I added a second service and...
I'm Currently working on nRF52840. I am trying to change Name for Beacon received from one of the Beacon's Characteristic and storing it in Flash. Now for name I am changing...
Good afternoon,
I'm connecting my nrf52840 device to my laptop, and it only shows up when being put in bootloader mode. Is there any way to fix this? Thanks in advance.
I am using power profiler from my MAC pro, to test my 51822 DK. And I got following errors:
Error while setting up device 000000123456: No firmware defined for selected...
Hello,
I am using nrf52840 dk and ses. I have written the code for hcsr04 ultrasonic sensor and I getting proper values but I want to send this data over bluetooth and I...
This is a very simple question:
According to the documentation, each dongle is assigned a Bluetooth Address at the factory using some random number generation algorithm...
Hello,
this question has been probably asked many times, but I could not find any good matches using the search.
My setup: I am using nRF52832, latest SDK 16.0.0 and a...
Hi everyone, We are doing a prototype with the nrf52840 module and I need to Certificate the board for RF emissions. I have some questions related this:
1- The BLE module...
