Hi,
I have a serious problem, when I use uart of NRF51822 QFAAC0 to receive data from another MCU, I found that it will lost one bit at same position everytime. my SDK is...
Hi,
I just started to interface the lcd display with nrf51822 evaluation board. The display i'm using is, spi compatible, 18" tft (160x130) from tiny lcd. I took spi master...
Hi,
We are using the nRF905 device in an application where it needs to switch between auto-retransmitting and sending single packets, due to it communicating with several...
This is not a real question for support. It's more a success story i'd like to share with you!
Our company develops firmware for various customers on a lot of different...
Hi all,
What is the maximum data rate for the nRF24AP2 when using the Synchronous serial interface?
I cann't see it in the datasheet.
Is there anyone can answer me...
Hi,
In my design, there is a tag used by 24l01,It can transmit the temperature value.In the tag, the parameters are like this:
addrofch[0] = 0xe7;
addrofch[1] =...
Hey I'm doing some SPI transfer in response to a GPIOTE in event. I'm targeting the NRF52840 and kind of went with the following answer:
https://devzone.nordicsemi.com...
Hello,
My setup is pca10040, sdk 14.2, s132.
I have tried firstly the blocking mode function and it is not reacting. After that I used SAADC module in a non blocking mode...
Is it possible to use the mbr, currently inside the softdevice, without the softdevice? Can we use the combination MBR/Application/bootloader? So we have a lot more flash...
I'm developing for the NRF52 DK (nRF52832) using VisualGDB (which uses SDK v11.0.0).
When completed my program is supposed to read data from sensor (via I2C), store it in...
Hello ,
is the NRF52810 surpport LE long range? is the mainstream mobile phone surppot LE long range? if i set the nrf52810/nrf52840 to be LE long range mode, and then ...
I am developing a product for indoor positioning and some thing else.
I want to know that how many beacon device can operate in same place.
As I know, beacon devices can...
All,
I already run BottonlessDFU example successfully after refer to below link. What's more, I added BAS and DIS service to Bottonless DFU example, and after use nrfutil...
Hello,
I found out that S/N from nrfjprog -i command returns the same number among different debuggers, all of them are 123456. At the same time, S/N showing from J-Link...
Hi,
I'm developing a peripheral that expose the HTS service.
I have the on_hts_evt event handler to handle BLE_HTS_EVT_INDICATION_ENABLED and BLE_HTS_EVT_INDICATION_DISABLED...
I am hoping to get solid verification that nordic offers a solution for sniffing BLE 4.2 packets.
The application I need to sniff is maxing out the MTU (250B payload) so...
i want to implement 2 hardware SPI communication in my code. i have one already working. talking with LCD ILI9341. the functions are using spi_write / nrf_drv_spi_transfer...
Our beacons are going into production, and to make function tests faster for our manufacturer we would like to transmit our beacon UUID, major, minor at a rate of 760ms for...
Just a question out of interest.
Is it possible to prevent the HFCLOCK from waking up on events and execute software on the LFCLOCK. I think this would be really useful...
