I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
Could someone paste the link to bluetooth specification v4.1? I can't find it on web. Probably it is avaliable only for SIG members, but I'm only a student and registration...
Hello, Dear friends,
I am new to Nordic, just have nrf52832 board come back, seems the current is higher than I expected before I program it.
does anybody know what is the...
Hello,
After digging through similar questions and answers I am still unable to build my code due to compiler errors. I am receiving these 5 errors:
Error: L6218E: Undefined...
I am working on a project using a ble nano (nrf51822) using the Nordic SDK 8.1. I am trying to use PWM to control a buzzer. To do this I included the following files into...
Hi,
I use Multilink Central and Experimental_ble_app_blinky examples.
Multilink Central sends only 1 byte. I want to send more.
Blinky does not work when I change the...
Hi all,
is there a way to set a characteristics when a read command arrive from APP, or it's necessary to set it before to read?
I see for example battery service, it...
How do I get data from a scan response packet using master emulator?
I do know about
BtScanParameters scanParams = new BtScanParameters();
scanParams.ScanType = BtScanType...
Hi, Nordic
Now, I have one nRF24 Dongle, two nRF52 devices.
two nRF52 devices will send data to nRF24 via ESB(gzll), but need to pair.
Can two nRF52 devices can pair...
What is the most energy efficient microphone input method, PCM via I2S or PDM. Does the SoC have a special HW handling of the PDM format for converting to PCM? Does the filtering...
Hello,
I am developing custom HAL driver for TWIM in NRF52 (PCA10040). The problem is that after the slave device stretches the clock signal, ninth period on SCL clock is...
Hi, i use the original ble_app_template (sdk11) with two lines of code added by me (See below) which erase the last page in flash (flash_page_erase((uint32_t *)(pg_size *...
Can you tell me what is the main different between nRF52832 and nRF51822 and can you send me following information about these products and nRF51822 Bluetooth Smart Beacon...
Hello ,
I'm working on custom board, I'm trying to disconnect from the Central (Andriod app) when the battery is below certain level and stop re-advertising.
Below is...
