Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
i made this project to try to create RSC service on arduino
developer.bluetooth.org/.../runningspeedandcadence.zip
unfortunately the server starts but i'm not able to...
Hello,
Could someone give me a hint with the following problem?
I am using two example projects (ble_app_uart_c, ble_app_hrs) to connect a central and a peripheral.
An...
I'm working on the C# nRFUart example found under C:\Program Files (x86)\Nordic Semiconductor\Master Emulator\2.1.13.14\Example code\nRFUart . In nRFUartController.cs the...
Lets assume i have 3 hex files:
softdevice.hex (addresses 0x0 to 0x1f000)
mySoft1.hex (addresses 0x1f000 to (0x1f000 + size of my program) and 0x7ff00 to...
Currently i am creating the ibeacon app for nRF52. App is able to display UUID, Major and Minor number of surrounding beacons. But is there any way to change the major and...
I have connected (BLE shield + Arduino Mega) with uploaded some Excercises code, It's working for 30 minutes with paired android device and disconnecting automatically.
...
Hello everybody!
I have a problem with compilers for nRF51822.
My problems: I create a pwm signal ~38Khz, duty 30% at pin 30 of nRF51822. This process is work well. I...
hi i m using nrf52 with a pi and the gatttool. pi as master and nrf52 as slave. i want to change the mtu but i got no answer from the nrf52 as you see in the log! do i have...
Hello, I have project to do, but I have too less knowledge about NRF's, I've tried almost all information sources and libraries, but no results. I have to make, that one PIC...
I lost many time and check 3 examples for various versions SDK, in all cases device can t connect to smartphone. Check with appl. "nRF UART 2.0" and last "nRF Connect". Applications...
I've spent the better part of a day trying to get the UART demo to work and I'm not having a lot of success. I did get it to connect and transmit data once - I think that...
Just noticed through some experimentation that the SD 7.1 Stack rejects Non-Connectable Advertising Parameters if the interval is less than 152.5msec? Error: NRF_ERROR_INVALID_PARAM...
Description : It is not possible to flash or debug an application with IAR on the Nordic target. This issue is caused by a bad interaction between CMSIS-DAP IF present on...
Hello,
I am developing a wireless sensor network to exchange body movement acceleration data with one Master and several Slaves. In the developing phase I am using the...
