Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
I would like to use a Bluetooth protocol analyzer for sniffing traffic in my Mesh network. I need to input the devkey(s), netkey, and appkey to the protocol analyzer software...
Hi,
I am adapting the uart example to send mensages between central and peripheral using JSON. In this moment I can send central <------>peripheral...
I have a problem...
HI I'm developing Mesh network with SDK for mesh 1.0.1.0
I just started with own provisioner code bud a really need some debug print while programme running.
I tried a...
i have created whitelists for filtering connection its working fine now, but when i restart my firmware the stored whitlists data become cleared so i need to bond each time...
Hi All!
I use "examples\peripheral\usbd\" example Project as reference to implement my own HID protocol.
I use only EP1 in/out 64 bytes both.
faced with a question,...
Is it possible for a peripheral device to start a Bluetooth Low energy advertisement and then read the RSSI value in the advertisement packet that it sent once a connection...
Hello,
I have some trouble to use fstorage function with dfu function,
please help to let me know the solution in order to solve the following issues,
thankful for...
Hi,
I'm getting back "01 10 06" when attempting to send 0x01 Start DFU to the DFU Control Point from my gateway which is a Pi3 running Noble. Notifications are enabled....
Hello, i've read in the infocenter that there is/will be a new nRF52840-PDK Hardware (v0.11.x). Is it already available? If yes, who distributes it? If no, when will it be...
nRF52832 SDK 14.2
Hi.
I would like to know how I can run a function in the background? In my case, I want to process a queue in the background. Here is the scneario: ...
Hi all,
after call inside the BLE_GAP_EVT_LESC_DHKEY_REQUEST I got error 8, what can cause it? a CONNECTION_SUPERVISED_TIMEOUT?
device nRF52, SDK13
Thanks
Board: custom board; Mesh SDK: V1.0.0; Softdevice: S132_5.0.0; IDE: SEGGER Embedded; BLE: nrf52832
When I test the example “Interactive PyACI”, I need one node(A) send message...
