Hi
I have add some function call like sd_ble_enable in mesh example, I test to get
then I set the address and all sd_ble_cfg_set is ok
but when I call "sd_ble_enable...
Nordic \ nRF5_SDK_12 nrf52832 using 2.0 _f012efa \ examples \ peripheral \ pwm_driver, pwm_driver example
Want to set up two road PWM phase is different, for example, the...
I'm using nRF52832 and S132 based on nRF5 SDK v14. I get a error code 4 when I add DFU service refer to the experimental_ble_app_buttonless_dfu . The SDK has changed so much...
Hi,
I'm wondering if I can get current transmitting channel during a connection. So
Is there a way I can directly read current transmitting channel?
If not, is...
This question has to do with the observed "recursivity" of the calls to "app_sched_execute" in SDK13 as described in the previously asked question below:
devzone.nordicsemi...
hi.
How do i do ble_app beacon advertisement to one device(Android phone) whose bluetooth address is known ?? I want that beacons should only be seen in nrf_connect app of...
why use 50ms and 400ms connection interval for testing the maximum data throughput(2M,247byte payload)?
Because 50ms can only send a pdu , and 400ms can send up to 8 pdu...
I successfully created a custom model (by modifying the generic on-off model) and implemented it into light_switch client and server examples. The goal was to send and receive...
Hello,
I have implemented functionality that enables me to send messages back and forth between two nodes in the network with a timer (both nodes has a server and client...
Hi I have been using the https://infocenter.nordicsemi.com/pdf/nRF_Sniffer_UG_v2.2.pdf I wish to program my nrf52832 device with a hex. Using the j-link commander tool. i...
Hi - I built and flashed the ble_app_interactive example from both SDK 15.3 and then from 16.0 on to my nrf52840 DK (PCA10056). I connect to a Thingy52, issue the gatt services...
Tried with PCA10036 and PCA10031 on Windows 10. Both show as JLink CDC UART Port (COMx) in Device manager. Tried different versions of WireShark. Tried to erase and copy new...
Hi,
Using SDK 15.3.0 , example "ble_app_hrs_freertos", pca10040 with armgcc.
I want to increase MTU and GAP data length.
I started with MTU to 247, and when I try to...
I'm using SDK 16.0.0.
I wish to use two MEMS microphones to record audio over the I2S interface, and then send it over Bluetooth.
What is the best library to use for this...
Hello,
I have had issues in the past with twi manager causing ANT to drop out. These problems are ongoing despite me taking action in hardware to improve power supply (e...
I'm debugging on an nRF52832 (nRF52-DK, non-preview) using the ARM GCC toolchain and GDB under Eclipse on Ubuntu 14.04LTS, set up following the devzone tutorial .
At various...
When calling sd_ble_gap_connect(), and providing a whitelist, what is the expected process for establishing a connection, as far as timing is concerned? Will the device scan...
nRF52840. In case of standby current (battery only)
Measured as follows:
With only the battery connected, the same current draw as the one attached. Is there any...
In my DFU bootloader I am protecting areas of Flash memory used to store user data.
After an update, when my application starts and tries to write to this memory it is causing...
