Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello!
I am using nrf52832 with SDK14.0 and SD 5.0.0
I have issue with Flash data storage. I am using code from example (fds_test from github)
Writting works good...
Hi,
nRF52832 uses which type of modulation technique?
Whether nRF52832 is Adatpive euipment or Non adaptive equipment . Please clarify?
Wireless module certified individually...
Hi all,
I am merging my code from Mesh 1.0 to 2.0.
I am trying to put both Provisioner and Simple On/Off Client into one board,
and then the other board is simple...
Hi,
May I ask what's the minimum reference circuitry for running nrf52810 without RF? Thanks.
Our need is as follows.
1) RF, eg, Antenna is not needed 2) GPIOTE 1 channel...
So I have my dongle sniffing for BLE packets and I can see all the advertising packets coming from the device, even the SCAN_REQ and SCAN_RSP.
But as soon as I paired the...
Hi Sir
The product is nrf52840 and SDK15, If I'd want to do following SPI operation ( CS to L ---> MOSI data {0x60, 0x00, 0x00, 0x11} ---> CS to H )
1. How to setup nrf_drv_spi_transfer...
I need to write a Windows program that talks to the nRF52840 Dongle. Is there a .dll or .lib or source code for communicating with the Dongle? I have programmed the dongle...
Hi
is the design (including schematics and pcb design) for nrf52 quadcopter is working one on the GitHub ( https://github.com/NordicPlayground/nrf52-quadcopter ) without...
Guys, i'm using a custom board with nrf52832 on it. The custom board doesn't have an external oscillator. So i'm trying to use internal RC oscillator. I am not using any softdevice...
Hi,
I want to program a NRF51822 custom board(waveshare) with NRF52DK using mbed
Can someone please help me with the tutorial
Thanks and regards
Siddharth
Hello Nordic Team
I am working on Raytac MDBT42V – 512K module. In this module doesn't have external crystal. So according to Raytac spec, it recommend to use internal 32MHz...
Hello,
I'm using BL654 module (nrf52840 inside); SDK15; softdevice s140; IAR.
In my projects I'm using peripherals: I2C(TWI), SPI. Project based on ble_app_uart example...
