In my design I need the RX to be standalone , I.E. no controller attached to it , does the programming STORE in the Chip ? If I set it up as a RX and set a specific Ch. Freq...
[Dev Env]
nRF51 DK
IoT SDK 0.8
IoT SoftDevice
[Question]
how i change my ip in ipv6_coap_server example use ipv6_address_set / ipv6_address_remove API.
To...
Hi Guys,
I have a MCU RTOS project. in Hardware board, builtin Nodic BLE chip over UART,RTOS BLE stack works fine.
We also have a MCU RTOS Emulator based on Qemu,we...
Hello,
I would like to have more info about canceling the pairing request on iPhone (thru the popup that asks if you want to pair with the device which is managed by iOS...
Hello everyone, I'm severely struggling to perform a simple task. I must be missing a very simple answer and, I hope with your help that I resolve the issue.
I am trying...
if the issue can be worked ,how to do that with android source code? the 2 ble pure devices (not android phone) connect with a ble android phone.
please check below, the...
Hi Nordic,
I used FDS to operate updata to update data more than 10K once, but there was an error. Hint FDS_ERR_RECORD_TOO_LARGE.Can FDS operate more than 10K data at once...
I want to create own android app with just nus service (uart).I'm not very good in android programming, so there are two ways for me doing that:
Use Android-nRf-uart...
Hey guys,
I have another question related to this example.
I've modified the UART example such that UART printing is disabled, and I am calling ble_nus_send_string(...
SDK 11.0.0
SD s132 2.0.1
nRF 52 dev kit
I have been in the process of adding dfu functionality to an existing application.
Currently, I have gotten the dfu to work...
Hi. I'm looking for streaming solution.
I think BT5 will be one of the great solutions.
I refered video as below.
www.youtube.com/watch
It shows that nordic chip...
Hello All,
I am working on one of the project using nRF51822 . in this project it requires multi communication protocols i.e i want to configure as below,
2xI2C
2xUART...
I currently have 2 redbear nrf51822 nano. I want to connect the UART of the nrf51822 to my arduino uno/nano but i dont know how i should do this. I tried looking for a solution...
Hello,
I am using PCA10040 and sdk12.2.2. I am trying to load ble_app_template code. But when I try to flash my code in pca10040 I am getting error as "No Jlink Device found...
I have a nRF51-DK and SDK8+Keil5.
I also have a module that sadly uses an old revision 1 nrf51822. It is connected via SWD to my nRF51-DK.
I could programm it with keil...
