We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hello!
I set up a project using NRF24L01 and a patch antenna ceramic, the type used in GPS.
In fact, I tested several types of antennas, F, F inverted, GPS, Loop. But...
Hello,
I'm trying to create a PC application to read out some Ti Sensor Tag modules. I'm using a nRF51822 USB dongle and the Master Emulator api.
The nRF dongle sees...
Hi there,
I have four nRF52 DKs, 52832 board. I make one board as client and three boards as server. After flashing corresponding softdevice and application firmware, they...
I want to give the application priority to run when it run with the bootloader.
I'm using PCA10028 and SDK12.
When the bootloader is uploaded with the softdevice, the...
Hi, I've read through partially of the "getting started" docs, and I'm still having questions about these issues:
Will there be one dedicated provisioner interfacing...
I was writing 3 character to ble device .but I got below error and ble device got disconnected. LED lights got off...
[CoreBluetooth] API MISUSE: <CBPeripheral: 0x1572b660...
Hi, when doing wired uart-BLE combination and increasing the traffic in the uart comms and BLE comms, at some unpredictable stage, the program flow goes to 0xFFFFFFFE. Any...
Hello,
I am trying to run the ble_app_uart_c example that is part of the nRF5_SDK_13.1.0_7ca7556 on a custom board with nRF52832 using IAR. Hardware seems healthy, I succeeded...
Hi all,
Could you please point me at the tutorial I missed... I am looking to adapt the title project to a custom project. I've run the sample and it advertises and shows...
Hi all
we are working on nrf52832 for our project.
not sure if there is guidelines for pcb antenna.
like limit on number of devices or any other certification we need...
Hi,
I'm using a nrf51 custom board (IC no. N51822QFAAH0) with Softdevice S130 v2.0.0 and SDK_11.
After connecting it with nrf Connect Android App, the device gets disconnected...
Hi:
I'm running S132 SoftDevice for the nRF52832 and am interested in configuring the nRF52832 (slave) to achieve connection intervals from 2 to 16 secs.
Thanks,
JP
On a custom board with an nRF52832 communicating over UART with another microcontroller with no flow control capability.
SDK 13.0.0-1.alpha with an S132SD.
I have some...
Hello everyone,
Thanks in advance for your patience in reading this long message.
I have been having problems with UART over USB on PCA10040 boards for almost four months...
In order to learn how to use the RTC0 to handle an event every second, I am debugging the rtc SDK example.
Expectation : The rtc example sets the time to check the counter...
