I have a zephyr zbus project running on the nrf52840DK that’s working well. We want to port the project to the nrf54H20DK, but I’m having trouble seeing the log messages....
Hi all,
we are wondering if there is a clean and reliable way to perform DFU on 54L15 via Thread? Our scenario: once the products get shipped to customers, the border router...
Hello,
We upgraded our project to nrf connect sdk v3.0.2 from v2.9.0 and can no longer use pin 0.00 and pin 0.01 as gpio. The problem seems to be in the nrf53 soc.c file...
Hi I am developing in 54L15. Now use DPPI to link
TIMER10's PUBLISH_COMPARE[3] ---> RADIO SUBSCRIBE_STOP,
it works fine.
Now I want to trigger a GPIO signal through...
Post:
Hi Nordic Team,
We are currently developing a product based on the Raytac MDBT50Q-1MV2 module, which integrates the nRF52840 SoC. Our firmware is built using the...
I use the security mechanism dtls based on udp communication. Can I implement it on nrf52833? How much flash and ram should be occupied at least? Is there a suggested value...
I am testing gnss without lte connectivity, which seems to work ok.
Except when I get "The modem has detected a reset loop. LTE network attach is now restricted for the...
In SDK 11 description od DTM "vendor specific" settings, there is a lot of inconsistency in parameters names/numbers - could anyone help me understand this part?
As for...
Hi,
Everyone,
I have firmware working with our custom pcbs.
It works fine with new 3.3v battery.
But somehow it does not advertise anything with used battery having...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
I guess we need some help with definitions. Basically, we'd like to read data from an I2C line. Should be as simple as "set to input" and "read the pin". However...
In...
Using nRF5 SDK v11.0.0, I am working on bringing up new hardware based on the nRF52. I started with code that works on the PCA10040 development board in which we connected...
I need to calculate radio on time in IoT SDK but IoT softdevice don't provide ble_radio_notification (in sdk components) and nvic functions (don't have nrf_nvic.h in softdavice...
My scenario is I have an android device and 100+ advertising nrf52 devices. Is it possible android to receive/scan advertising packets (small) from 100+ devices which mean...
error occurs in nrf_delay.c of nrf52832
Because there are ASM in nrf_delay.h
nrf_delay.c:
#include <stdio.h>
#include "compiler_abstraction.h"
#include "nrf.h"
...
Hello,
I cannot find an example in the current SDK on how to use APP_UART. I do not want to use app_uart_fifo because it has quite some overhead that I do not need. All...
I am using nRF5_SDK_11.0.0_89a8197 to test esb maximum throughput.
in the macro definition of NRF_ESB_CREATE_PAYLOAD,
#define NRF_ESB_CREATE_PAYLOAD(_pipe, ...)
...
On the nRF51, there are 5 OVERRIDE registers (0-4) in the radio module.
What do those registers do and when should they be used? The FRM was not clear about them.
From what I can see the scenario where you have a serialized app running from a separate CPU and how to do firmware update on that is not discussed anywhere on the Nordic...
