We have developed an application which uses the nRF9160 together with the same GPS and Ethertronics/Kyocera/AVX antennas as that of the nRF9160-DK . For the LTE antenna, we...
We're trying to measure supply current used by the NRF9151 DK but have discovered that the current measurment connector (P22) only includes current supplied to VDD, and that...
Hi,
I'm using the nRF52833 to develop a BLE beacon and built a Bluetooth gateway for my application.
Application Requirements:
The beacon should advertise using...
Hello,
I want to perform some antenna measurements and compare the rf performance of my custom PCB with an nrf9160 SiP with the nrf9160 dk.
To perform some antenna measurements...
Hi I want to build a multi role BLE device.
As a peripheral it shall stream ADC data with arounf 20 kbytes per second.
As Central it shall receive adv_nonconn_ind packets...
Dear Nordic Engineers
I developed a PWM function to drive the RGB LED. Then I found a problem, which is w hen I used a PWM signal of one channel to control the RED light...
I get error provisioning key on nRF54L15 and NCS 3.0.1. I tried using "Erase all" in nRF connect SDK Programmer, but it doesn't help. Please check also the attached log. nrf54l15dk...
Hi,
I'm developing custom PCB with nrf51822 (low voltage mode) and I have troubles with flashing the chip. I cannot see the chip in nRFgo Studio. I can flash original devboards...
Dear SOC developpers,
As many kickstarters i bought an RFDUINO kit, then I made a cool prototype thanks to the easy Arduino compatibility. I'm now thinking of industrializing...
Is there a simple software code example how to configure an interrupt handler for a single GPIO-pin? I am using nRF51822 chip with softdevice S110 and the interrupt source...
My question a little weird. Because I am super beginner about BLE. So what I want is how to write string data. now i am looking to information about this. I cannot find it...
Hi
I'm trying to implement bonding in a device based on the S120. As counter part i've used a S110 device or an iOS device (realized with LightBlue App).
While searching...
Hi All,
I am using nRF51422 and now doing ANT+ certification test with tool v1.3.6. And i find out some problem with the received value on my display in case of following...
Hi
i am not able write my application after I flashed the SD. I am using Jlinker lite (the one that comes with the Dev kit) and the scripts from the nrf pure gcc . I modified...
Hi everyone,
Is it possible to connect 2 devices simultaneously with the nRF51822 device? As soon i connect one device, the advertisement stops.
So, for me it would be...
I've already posted my problem here. But it seems a dead thread.
devzone.nordicsemi.com/.../nrf51822-timer-problems
I ran into trouble when using the app_scheduler without...
Hi, I've been trying to use the timers on nRF51822 but I just can't get them to work in my code. When debugging (with GDB and Eclipse), the execution always stops with the...
Hello.
I've asked a question a while ago, devzone.nordicsemi.com/.../sd_flash_page_erase-failing-with-s120
I've been using Linux, jlinkexe, and gcc that time. Now I...
I just got the new Nordic "mbed" dev board and have started experimenting with it.
In another thread it is explained that the softdevice is bundled into the generated ...
I am getting following error:
Error in final launch sequence
Error executing step execute method: stepInitializeJTAGFinalLaunchSequence
java.lang.reflect.InvocationTargetException...
