Hi,
I have a SPI slave device which outputs 8-bit registers that I have to assemble. For example, I receive two 8-bit registers, a high and a low register, which I have...
I have a PCA10059 dongle. I have inadvertently configured pin P0.25 as the sleep debug pin and I use active state 0 as I am using off board LEDs with reverse logic. This means...
If you're working on a product that requires you to show and translate GATT Attribute (Service, Characteristic and/or Descriptor) UUIDs to Strings to the user, it's likely...
Hello,
We have been trying the sendNotification call and after getting a success log we are not able to send a second notification. I'll copy the snippet of code that we...
I have a firmware developed on the nrf52840 development board. When porting it to nrf9160, a lot of errors were reported. How can I use the LOG output function on nrf9160...
Hi I would like to ask you for advice on how to solve my problem with Ble and the timer I am trying to add a timer to examples\ble_peripheral\ble_app_uart the timer works...
I am referring SDK 12.2.0 with Eddystone beacon application and I found that the workspace for IAR is missing in it and I have IAR-ARM license. So, I made my own workspace...
I am using a 1822 chip and I need to use it in a very small application so I need to program it separately from the main device. I have a learn.adafruit.com/.../overview FTDI...
I've tried everything to get a RTT log message to show up from a dev kit to my computer. The uart log works but no combination of settings will get any RTT message to show...
Hi,
I'm porting an older application from Keil to SES. I'm using soft device S110 7.1 and the nRF51822ac.
Help in setting up SES FLASH and RAM would be most appreciated...
I have been working on a project (for profit) that uses a BLE Nano device along with Nordic SDK. To start the project I downloaded a copy of the Nordic SDK 8.1 examples and...
Hello,
I just downloaded Keil and ran through a few tutorials for the nRF51 Dev Kit, so I am brand new to this development environment.
I am trying to get the nRF51422...
Hello Nordicsemi,
i need to develop a system in which i have identify a user presence in a particular area
for that i m planing to design a BLE enable device for a user...
Hi,
I followed the steps to setup my nRF52 DK with eclipse. I could also build the code without errors. However, when I try to debug it, it says cannot connect to J-Link...
I am working on a project using a ble nano (nrf51822) using the Nordic SDK 8.1. In the examples I found a way to control an LED using the methods LEDS_ON and LEDS_OFF. I wanted...
Hi all, I am trying to use the UART hardware module inside the nRF52 DK. I am very new programming with Nordic chips and C, my previous experience is programming Arduino and...
I don't have a QFN package, I have a WL-CSP package. Presumably, this define should be changed to NRF51822_??AA_??, but I can't find anyplace where the options are listed...
Please can any one tell me that how to recognize the sdk version of that we are used it can be predict from softdevice version?
for ex. •S132 SoftDevice v2.0.0 is used in...
