Greetings!
Briefly summarized: I am trying to generate SPDX files for our project, but I hit some roadblocks while running the west spdx command. I found a way to workaround...
Hello,
I'm trying to make the nrf5340-DK capable of connecting to BLE from multiple devices.
The program is based on: Bluetooth: Bluetooth: Peripheral UART .
I found...
Hi all,
I'm trying to use rtc0 with my custom board build with an nrf9151, but I got a secure fault. I've activated rtc in an overlay file
In my prj.conf
But...
We are implementing a Joiner device using OpenThread on the nRF5340 (with Zephyr, NCS v3.5.99-ncs1-4). After successfully joining the Commissioner's network ("Join success...
I purchased a SIM data from ILIAD and I am trying to connect to network, but the AT command AT+CEREG? : +CEREG: 0,4 instead of 0,5 as I expect.
The lte_lc_connect_async...
In order to reduce power consumption , I configured the RX pin of the serial port with an interrupt , and when the device was asleep , it was woken up by an interrupt , and...
Hi I am using an nRF54L15 with an external watch crystal. I have notice that depending on the manufacturer of the crystal I have to use a different internal load capacitor...
I have my radio chip set up so that it pairs with an iOS device via an encrypted bluetooth connection. Everything works great -- however I'd like to be able to "unpair" from...
Hi,
we are using the chip nRF51822 CEAAE00.
We want to use the pin 0 as output. It is configured as below
NRF_GPIO->PIN_CNF[0] = (GPIO_PIN_CNF_SENSE_Disabled << GPIO_PIN_CNF_SENSE_Pos...
Hi,
I using nRF51822, S110 and NUS to send the data to the phone.
When sending the data, I using ble_nus_string_send function.
I need the execute time to the phone...
When scanning for peripherals using the Master Control Panel Android app, most of the various BLE devices scattered around me show up with a "connect" button next to them...
I have a development board with the AC variant, but for my custom board I have an AB. I am able to flash code using Keil to the development board, but when I change the device...
Can anyone suggest an I2C LCD driver for use with the nrF51822? We will likely be driving a 96-segment LCD but a dot matrix LCD may be an option.
The application is for...
I get the following error on doing OTA DFU using an Iphone with IOS V8.4.
Created .zip files using nrf.exe
Commands used
nrf dfu genpkg --application...
Hi everyone,
We're working with nFR8002 devices, and it works fine most of the time.
Even after losing the link intentionnally (Bluetooth stopped, or walking out of Bluetooth...
This question devzone.nordicsemi.com/.../ appears to show that S132 expects the FPU to be available and activated.
Does the S132 really need/use the FPU or is this an artefact...
Hi,
I know that when advertising in non-connectable mode, the fastest advertising interval is 100ms. I have some questions about this:
Is there any document explaining...
I have been using NRF51822 for some time as BLE chip with services.
For some debugging reasons I need a faster stream method...
I looked at Gazell and found it simple to...
Hi, I have a question about this memory layout .
At Figure 2 (of the memory layout), it erases the previous application.
After that, at step 1, it says that the firmware...
