After ping through link local address ,i am not getting any Router solicitation messages,neighbor solicitation messages and neighbor advertisement messages while i am capturing...
Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
I am using the Dynastream D52DK1 ANT starter kit -based on Nordic Semiconductor’s nRF52832. According to the documentation given by Dynastream,
Open the desired project...
Hej, I stumbled upon a linker error saying
Output/serial_pca10040 nrf52832_xxaa/Obj/hardfault_handler_gcc.o: In function `HardFault_Handler_Continue':
hardfault_handler_gcc...
Hi, I really hate to ask this question but so far I have only managed to find 2 similar questions with 0 about nrf52840.
I'm using nrf52840 S140 5.0 alpha3.
When calling...
Hello
I have a problem...
'python_packages.bat' file can not be installed...
error message:
'python' is not an internal or external command, executable program,...
I have the nRF51-DK working on two separate computers with Keil v5.13 and the latest SDK. However, on my main computer I am having trouble with Keil and nRF51-DK. When I try...
Reference circuitry for nRF52832 with internal LDO setup says that C6 should not be mounted. Does it mean that DEC2 pin (32) should be simply grounded or it can be left open...
Hello everyone,
Im triying to replace the original 3D imagen from Thingy 52 Android App, but always i replace it for another one, the apps Crash when i go to Motion menu...
I have been developing a program for the nRF51-DK that reads an input value from an analogue input pin and displays this on PuTTY(terminal emulator software) using the UART...
This is for the nRF51822.
I have done some tests where I configure a pin as input with pull up enabled and then reconfigure the pin for an adc measurement with 1/3 prescaler...
Hi,
Just wanted to point out that I noticed that after pressing Button 1 to put the device into connectable advertising mode, LED 3 turns on as expected. But if the connectable...
I want to make a PCB with the nRF51422 chip on it. Is there a way of programming it externally using the nRF51-DK? If so, what connections do I need between the PCB and the...
