Greetings!
I am using Wireshark along with an nRF52840 dongle to monitor BLE traffic between a mobile app and connected peripheral and periodically I see some "L2CAP Fragment...
Hello, I am using the nRF54L15 board, and trying to connect to the Adafruit SHARP 400x240 monochrome LCD display .
I got the display driver alone to function just fine after...
Hi,
I am trying to perform a DFU using SMP over BLE. My setup has NSIB and MCUBoot enabled and thus I am able to perform DFU for MCUboot and Application using nrf device...
Hi all,
I'm trying to use uart2 on my custom nrf9151 board, but I'm stuck. As I understand, I use i2c1 so I can't use uart1 and i2c1in parallel, so here is why I wnt to...
Hi - I am seeking clarification on a topic as I am a little unsure on the correct way to do things.
I'm using an nRF52840 and porting an old Firmware from nRF5 SDK to NCS...
Hello,
I'm moving my project from SDK1.9.1 to SDK3.0.2. Project is based on peripheral_uart sample (UART part is removed since it is not necessary).
I have encountered...
Hi, i'm using NRF5191 with DECT.
DECT modem: 1.0.2
App: hello_dect sample
In datasheet I found that NRF9151 support various band: 1,2,4,9,22
and I'm using these value...
Hi Nordic
I don't fully understand the drive settings for the GPIO. For example S0H1 means when the pin is CLEARED, it will use standard drive (can sink 0.5mA) and when...
Hi there,
i was trying to implement a firmware for a small device using the nRF8001 only in broadcasting mode.
So far, everything works fine. But one thing mentioned...
I'm happy with the status of my app on the evaluation board and I'm ready to start downloading it to my target board. I plugged the Segger J-Link Lite CortexM board into one...
I'm looking into the service creation portion of BLE, and I've made it pretty far. But one problem that I'm running into is sending more than 8 bits of data at a time back...
Now I am doing the BP by using the "ble_app_bps" project. I find it still advertising after connecting to the master,so the power consumption is high.So I wanth to use the...
The nRF8001 provides pipes to the Characteristics on the local GATT Server and the remote GATT server. How is this different from the handles of Attributes.
The setup for the nRF8001 that is generated by the nRFgo studio can be placed in NV-RAM or the RAM of the nRF8001. Is it possible to put a new Setup in the NV-RAM or put in...
We have some profiles that has power saving modes that changes the advertisement parameters while running. We want to change the advertising parameters from the application...
The Master Control Panel uses the PCA10000 board loaded with a ME (Master Emulator?) firmware.
Is it possible to get the source code to this firmware in order to make your...
the nRFgo studio is used as a visual editior for the nRF8001 to create Bluetooth low energy Services and Characteristics and Pipes to access them. After creating the Service...
