Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello, nordic team；
I want to create a DFU for the ANR + BLE device in the nRF5_SDK_12.3.0_d7731ad \ examples \ dfu \ experimental_ant_bootloader routine.But I use this routine...
Could someone explain the difference between the following functions:
ble_conn_params_change_conn_params(ble_gap_conn_params_t *new_params)
sd_ble_gap_conn_param_update...
Hi all,
i need to have at one to one connection(one phone on one nrf52). I have created a whitelist.
What i can see is that after a pairing and a bonding, if i delete...
Hello,
I'm working on an UART application which uses experimental_bootloader_secure_serial bootloader. I've done a similar thing before with SDK-11 (though not a secure...
Hi,I use S130 V1.0 working as a master,and connect a device.My device adverting interval is 800ms， and gap_conn_params.min_conn_interval = MIN_CONN_INTERVAL;//MIN_CONN_INTERVAL...
So I thought I would upgrade one of my projects to SDK13 and try out SES 3.24 at the same time. I thought I would start by getting the ble_app_uart_pca10040_s132 project to...
Hi.
I just want to upload BSP package to my NRF51 DK via mbed web app, but i can not find proper source from all the available projects in mbed. Tutorial of BSP also doesnt...
Hi,
i set the app_timer to fire every 60 seconds
app_timer_start(m_Timer_id, APP_TIMER_TICKS(60000, APP_TIMER_PRESCALER), NULL);
Is it possible to get the current couter...
Hi,
I have changed the ble_app_uart_c example so that it can connect to multiple peripherals(at the moment 2 peripherals, the goal is 3 peripherals). It works fine, but as...
Hi,
I had develop a peripheral with passkey in SKD12.2.0. Now i want to develop ble central to connect the peripheral and communicate with it. i don't know how to implement...
Right now I am facing a problem as mentioned below:
I downloaded nRF52 SDK version 12.3.0. It contains lot of example code. I found .eww file in each example project folder...
I am planning start to develop new sensor base nRF52832.
My question is if it's possible to receive the.DSN file of the NRF52-DK board (development kit)
It will be very...
