But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
HI,
the solution I'm working on requires quite a few IO pins, so once I ran out of regular GPIO pins I had to resort to using NFC ones.
I changed the UICR registers...
I am using the Dynastream D52DK1 ANT starter kit -based on Nordic Semiconductor’s nRF52832. According to the documentation given by Dynastream,
Open the desired project...
Hej, I stumbled upon a linker error saying
Output/serial_pca10040 nrf52832_xxaa/Obj/hardfault_handler_gcc.o: In function `HardFault_Handler_Continue':
hardfault_handler_gcc...
Hi, I really hate to ask this question but so far I have only managed to find 2 similar questions with 0 about nrf52840.
I'm using nrf52840 S140 5.0 alpha3.
When calling...
Hello
I have a problem...
'python_packages.bat' file can not be installed...
error message:
'python' is not an internal or external command, executable program,...
I have the nRF51-DK working on two separate computers with Keil v5.13 and the latest SDK. However, on my main computer I am having trouble with Keil and nRF51-DK. When I try...
Reference circuitry for nRF52832 with internal LDO setup says that C6 should not be mounted. Does it mean that DEC2 pin (32) should be simply grounded or it can be left open...
Hello everyone,
Im triying to replace the original 3D imagen from Thingy 52 Android App, but always i replace it for another one, the apps Crash when i go to Motion menu...
I have been developing a program for the nRF51-DK that reads an input value from an analogue input pin and displays this on PuTTY(terminal emulator software) using the UART...
This is for the nRF51822.
I have done some tests where I configure a pin as input with pull up enabled and then reconfigure the pin for an adc measurement with 1/3 prescaler...
