Hi,
1.How to modify the transmission power of the example direct_test_mode to 4dBm? 2. Please provide Method 1 and modify it using the CONFIG configuration? 3. Please provide...
Previously, I designed a PCB for the nRF52832 chip using the RFANT3216120A5T antenna ( link ). However, I was only able to achieve a very limited Bluetooth range of around...
Hi, I'm relatively new to Nordic microcontrollers and have recently completed the beginner's course. Sorry in advance if I made an obvious mistake.
I am currently trying...
We are running a nrf54l15 board that uses an NFC T2T tag to encode a URI to open an application. We have noticed that sometimes, the current stays higher (~200 uA) after the...
I’ve got a bit of a hardware issue with the nRF52811 UART, receiving DMX data from a Chinese DMX controller.
Standard DMX data-rate is 250Kb/S, so the minimum bit time is...
Hi,
I am using the Nordic UART Service (NUS) peripheral and central on two nRF52840 DKs and I am developing with nRF Connect SDK v3.0.0 .
I can't manage to increase the...
I am getting an occasional softdevice assert on a BLE central device (hub). Both the central and peripheral devices are nRF52840 using Coded PHY and NCS v2.7.0. This error...
The S120 is a pure Central softdevice, and hence it can connect only to other Peripheral devices. Does it means that s120 cannot be used as a peripherial device?
Hello all,
I have been using nrf905 for about 5 years without problems.
now I would like to ask if is there any way to use an external PA? I am not a RF engineer and i...
Hello,
I've an issue only on IOS. My custom service is recognized as immediate alert and crash when we want to use it. It works fine on android and with Master Control...
Hi - I'm trying to use the pure-gcc make files and I've got my project building and the code is running, but when I try to launch startdebug gdb it reports no debugging symbols...
Hi
I cannot find the answers from your documents. Please help me answer them. Thanks.
DC supply voltage of core cell of nRF51822 chip?
DC supply voltage of IO pad...
I am using a modified sample of your rangedemo example and can get it to work. To test if I am switching to 915MHz I change the HFREQ to 1 but the receiver that is set to...
Hello
Im starting a new project and i wanted to save time by asking if there is a list of providers or company that produces sensors that will have an easy compatibility...
Hi,
I need to store an image of size 40kB to internal flash memory. Actually i tried to store it from the address like 0x28400 and 0x2E984 (memory addresses after softdevice...
Hi, I am developing an BLE application using nRF51822.
This question is from my previous question:
devzone.nordicsemi.com/.../question-about-adc-power-consumption
...
i have purchased one of the modules. i need to interface with other modules of the same kind but how will i start programming it ,can u people suggest me the IDE ? do i need...
Hi,
I try to modify 51822 device_firmware_updates code for 51422.
But I have a problem.
When I run my code, my cell phone can connect to 51422. I can click DFU button...
According to Page5 of nWP-018, if we compare QFAA G0 to C0, G0 doesn't have a valid version reference design with the right balun. But G0 and C0 have the same valid reference...
Hi there,
We're looking to use the entire 16 KB of RAM on the nRF51822 when the S110 is disabled. We've come across an odd case, where doing this:
memset(0x20000004...
